Oldsmobile Regency Clean and Repack Wheel Bearing at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(589)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(589)

Clean and Repack Wheel Bearing Service

How much does a Clean and Repack Wheel Bearing cost?

On average, the cost for a Oldsmobile Regency Clean and Repack Wheel Bearing is $152 with $0 for parts and $152 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1997 Oldsmobile RegencyV6-3.8LService typeClean and Repack Wheel BearingEstimate$183.98Shop/Dealer Price$199.99 - $211.99
1998 Oldsmobile RegencyV6-3.8LService typeClean and Repack Wheel BearingEstimate$151.98Shop/Dealer Price$168.01 - $180.04
Show example Oldsmobile Regency Clean and Repack Wheel Bearing prices

What is cleaning and repacking the wheel bearings all about?

A car’s wheels rotate on tapered-roller bearings which fit between the stationary axle spindle and the rotating wheel’s hub/brake mechanism. There are bearings on the inner and outer side of the hub to properly support the wheel. These are greased when installed, but the grease can, and does, break down over time, allowing dry contact between the various elements. When left unattended, this will lead to wear and, ultimately, to bearing failure.

Keep in mind:

  • Since noise is the first symptom of metal-to-metal contact, it’s likely that damage has already occurred, and that bearing replacement may be necessary.
  • The job will require the removal of the wheel and brake assembly, so it might be advisable to inspect the brake pads, steering tie rods and suspension pieces in the process.
  • If you’re going to do one wheel, it’s only logical that you should also do the other side.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The front or rear wheels, brakes and hubs are removed from the vehicle
  • The front or rear wheel hubs, bearings are cleaned and greased then install a new grease seal in hub
  • The front or rear wheels, brakes and hubs are installed back on the vehicle
  • The vehicle is lowered off of the jack stands

Our recommendation:

Consider having this job done when your vehicle reaches high mileage, particularly if it has been operated with heavy loads or on unusually bumpy roads.

What is a common symptom indicating you need to clean and repack the wheel bearings?

  • Any noise noticeable from the wheels. It can start as a squeal, and then develop into a growl or even a grinding sound.

How important is this service?

A catastrophic wheel bearing failure can lead to the wheel coming off the car. Obviously, that could cause an accident or, at the very least, serious damage to the vehicle. It’s certainly worth discussing with one of our mechanics.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Oldsmobile mechanics

Real customer reviews from Oldsmobile owners like you.

Excellent Rating

(589)

Rating Summary
537
27
6
6
13
537
27
6
6
13

Natnael

8 years of experience
5 reviews
Natnael
8 years of experience
Oldsmobile Regency V6-3.8L - Door Mirror Replacement (Passenger Side) - Potomac, Maryland
He installed a new outside, electric remote control mirror on my mother's car. On time; professional and cordial. I could not have expected more. Thanks.

Joseph

33 years of experience
540 reviews
Joseph
33 years of experience
Oldsmobile 98 V6-3.8L - Crankshaft Position Sensor - McKinney, Texas
Fast, efficient and extremely convenient. Joseph is friendly and knowledgable on the necessary repairs and did it for a fair price. We will be using him again in the very near future.

Ben

41 years of experience
1441 reviews
Ben
41 years of experience
Oldsmobile 98 V6-3.8L - Oil Pressure Light is on - Houston, Texas
They just sent an email saying the mechanic is on his way. It is only 8:12 am! He is off to a good start. He is supposed to arrive between 9:00-9:30 am. He arrived well before that time! It was not 9:00 am yet! He did a diagnostic and he checked all the work I did. He said I did great work with everything I did. He said the car is very good shape. He said this car is indeed a runner! He checked everything. He checked all the fuses and relays too. He did a complete diagnostic too. He checked fuel pressure, oil pressure, and more. He found out what it was. It had nothing to do with oil pressure or anything. The fuel pump is going out. When he came the car started right up. He said they never go totally out. He said that is why it started when it did. He connected tools I do not have to the Ninety Eight. It is not getting any fuel pressure, and this is why it shut off all the times it did. He fixed one of the spark plug wires too. It was burnt. He jacked the Ninety Eight up and got underneath and checked the wires, the oil pressure sensor/switch and oil level sender for everything and the connections and made sure they have power and were installed correctly. He said the engine uses oil pressure along with the fuel pressure to start. The fuel pressure is non existent and that is why it would not start. After all of that, he looked at the Oldsmobile Toronado, my other car . He got the air conditioner to work again. He said the compressor bolt was loose and he tightened it up. He used this huge screw driver device and bent it back in place. He said the shims were loose and he bent them back. It cools just fine now. We turned it on and off several times testing it. He checked the pressure and it was filled with refrigerant. He checked the relays and the fan too. It was all fine. He said it is clear you take care of both of your cars. He said one thing I will not do is guess and I like to know what is indeed wrong. He said your cars are in good shape. He said you do not need valve cover gaskets. There is no leak. I booked him to return to install the fuel pump I need. I look forward to seeing him again soon in a few weeks. Today only cost me 70.00. That's it.

Todd

26 years of experience
95 reviews
Todd
26 years of experience
Oldsmobile Cutlass Ciera V6-3.3L - Oxygen Sensor Replacement (Front/Upper/Upstream) - Gloucester Point, Virginia
Todd is the best! A really great man. Need more like him.

Excellent Rating

(589)

Rating Summary
537
27
6
6
13
537
27
6
6
13
Number of Oldsmobile services completed
6479+
services done by our mechanics
TOTAL NUMBER OF EXPERT Oldsmobile MECHANICS
300+
experts on our platform

Recent articles & questions

How to Adjust Your Headlights
If you have ever cursed an oncoming driver because their lights were blinding you, or noticed that your lights tend to illuminate the...
How to Drive Your Vehicle Through a Flood
It can be dangerous to drive a car through water. Approach the flood in a low gear and find a safer route if the water is too deep to drive through.

My air vents sometimes stop working.

Hi there. Anytime something is not functioning all the time and is randomly shutting off, then there is an issue with the relay of that circuit. Check the relay to the fan motor circuit and see if there is power...

Car Vibrates after spark plug change

Shaking or vibrating may be caused by many different things such as faulty spark plugs, poor fuel pressure or misfires. Other things such as a faulty idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) may cause the engine idle to drop below the...

I have a 2006 Suzuki Forenza and recently just got the engine replaced. after driving it for a while yesterday the malfunction ind

Without knowing what caused the check engine light to come on or the codes stored it would not be able to be determined if engine damage can occur if you continue to drive it. I would recommend having the codes...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com