Nissan NV200 Fuel Injector Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(10)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(10)

Fuel Injector Replacement Service

How much does a Fuel Injector Replacement cost?

On average, the cost for a Nissan NV200 Fuel Injector Replacement is $1275 with $911 for parts and $364 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2018 Nissan NV200L4-2.0LService typeFuel Injector ReplacementEstimate$2336.28Shop/Dealer Price$2828.96 - $4285.94
2017 Nissan NV200L4-2.0LService typeFuel Injector ReplacementEstimate$2202.07Shop/Dealer Price$2662.47 - $4032.92
2013 Nissan NV200L4-2.0LService typeFuel Injector ReplacementEstimate$2930.07Shop/Dealer Price$3572.53 - $5489.03
2014 Nissan NV200L4-2.0LService typeFuel Injector ReplacementEstimate$2920.93Shop/Dealer Price$3561.10 - $5470.75
2016 Nissan NV200L4-2.0LService typeFuel Injector ReplacementEstimate$2920.93Shop/Dealer Price$3564.94 - $5477.45
2015 Nissan NV200L4-2.0LService typeFuel Injector ReplacementEstimate$2943.83Shop/Dealer Price$3590.09 - $5517.19
Show example Nissan NV200 Fuel Injector Replacement prices

What is a fuel injector and how does it work?

A fuel injector is a fuel metering device that sprays atomized droplets of fuel in a specific pattern into the engine’s intake manifold or directly into the combustion chamber. The injector has a solenoid and valve within and the operation, or pulsing, of the solenoid is controlled by the powertrain control module (PCM). The PCM controls the solenoid’s “on” time in order to keep the air-fuel ratio optimized while the engine load and operating conditions constantly change. Fuel injectors are usually connected to a fuel rail located on the top of the engine and the fuel rail, in turn, is supplied with fuel under pressure from the fuel pump located in the fuel tank.

When to consider replacing a fuel injector:

  • Rough idle, loss of power, or misfiring. Poor engine operation has many causes but faults in the fuel injection system, including the fuel injectors, are high on the list of possibilities.
  • Odor of raw gas or visible leaks. Fuel injectors should not leak fuel into the intake manifold when the car is off. If you notice any fuel odor around your car, the possibility of a leaking fuel injector should be considered. There should be no external leak from a fuel injector. If an externally-leaking injector is suspected, do not start your car due to the fire hazard.
  • Check engine light. Some fuel injection failures, for example, a faulty solenoid, may cause a trouble code to be set in the PCM and that will cause the check engine light to illuminate. The codes are read and the fuel injector is tested directly, as needed.
  • Major engine repairs, engine replacement, or lengthy storage. All fuel injectors will have deposits given enough mileage. These deposits can cause an imbalance in the performance of the injectors from cylinder to cylinder. When an engine is already disassembled, or if you are installing a new engine, that is a perfect time to service the injectors as a set. All injectors have tiny internal filter baskets. A professional injector service facility will clean each injector ultrasonically and replace these filters for a relatively low cost.

How do mechanics replace a fuel injector?

Injectors can be serviced once removed from the car or replaced outright with new injectors. If the injectors are serviced, specialized cleaning and test equipment are required. The choice to repair versus replace will depend on exactly what is wrong with the injector as well as customer preference. Either option requires removing the injector from the car and the following procedure is typical:

  • Once the engine is cold, the pressure within the fuel rail is relieved by briefly running the engine with the fuel pump fuse out.
  • The upper plenum on the intake manifold is removed along with any cables, hoses, or wiring that restricts access.
  • The supply and return lines are removed from the fuel rail. The electrical connectors to each fuel injector are unlocked and removed. The fuel rail is then unbolted and removed from the intake manifold.
  • The injector(s) requiring replacement are removed from the fuel rail, taking care to not allow any debris to enter the exposed openings. An O-ring seal usually holds the injector very firmly in a finely polished bore in the fuel rail.
  • Using a new O-ring, the serviced or replaced injector is re-inserted into the fuel rail — using engine oil on the O-ring to prevent damaging it. O-rings in this application fit very tight to prevent fuel leaks.
  • The fuel rail is re-installed and the supply and return lines are re-connected. The plenum is re-installed along with all cables, hoses, or wiring.
  • Finally, the engine is run, there is a careful check for leaks, and the vehicle is road tested.

Is it safe to drive with a fuel injector problem?

Yes, so long as there is no external leak of fuel from a broken or malfunctioning injector, it is safe to drive the car. However, if the injector is known to be malfunctioning, it can cause engine misfires, excessive emissions or, in the case of a badly leaking injector, can overload and overheat the catalytic converter. Additionally, fuel efficiency will always be diminished if the fuel injectors are not working properly.

When replacing a fuel injector keep in mind:

  • Using high quality (Tier One) gasoline may reduce deposits on fuel injectors and prolong their life.
  • If an injector problem develops that requires removal of one injector, the best practice is to remove and service all of the injectors at the same time. That service might involve replacement of the electrically failed injector along with off-the-car cleaning of the remaining injectors. Serving all injectors at once ensures the injector set will be balanced, in terms of flow rates, and in turn promote smooth operation of the engine.
  • Do not use fuel system cleaning compounds, or procedures, unless such materials are specified by the manufacturer of your car.
  • On the car cleaning of fuel injectors is not as effective as off-the-car cleaning because injectors have tiny internal filter baskets that should be replaced as part of the process of servicing a fuel injector.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Nissan mechanics

Real customer reviews from Nissan owners like you.

Excellent Rating

(10)

Rating Summary
10
0
0
0
0
10
0
0
0
0

Stacy

25 years of experience
511 reviews
Stacy
25 years of experience
Nissan NV200 L4-2.0L - Oil Change - Stone Mountain, Georgia
Fast, professional, and friendly! Great experience.

Theodore

17 years of experience
1794 reviews
Theodore
17 years of experience
Nissan NV200 L4-2.0L - Oil Change - Redmond, Washington
appreciated the thorough work

Ramiro

22 years of experience
103 reviews
Ramiro
22 years of experience
Nissan NV200 L4-2.0L - Oil Change - Seattle, Washington
Very good did oil change in no time!

John

37 years of experience
565 reviews
John
37 years of experience
Nissan NV200 L4-2.0L - Oil Change - Sacramento, California
John was awesome. Very fast and personable.

Excellent Rating

(10)

Rating Summary
10
0
0
0
0
10
0
0
0
0
Number of Nissan NV200 services completed
110+
services done by our mechanics
TOTAL NUMBER OF EXPERT Nissan MECHANICS
1600+
experts on our platform

Recent articles & questions

How to Replace Your Car's Fuse Box
A fuse box organizes all of the car's fuses and sometimes relays as well. A fuse box will usually fail from physical damage or electrical issues.
What Causes an Oil Filter to Get Dirty?
At At some point during your time as a vehicle owner, you’ve likely had your oil filter changed, probably at the same time as an oil change. Few people give this minor maintenance more than a second thought. After all,...
P2279 OBD-II Trouble Code: Intake Air System Leak
P2279 code definition Intake Air System Leak What the P2279 code means P2279 is an OBD-II generic code for the engine control...

My car stalled, I checked the oil and it was low. I added 2 quarts and barely made it 4 blocks. There is no pressure when pressing the gas.

This may or may not be related to the low oil level (https://www.yourmechanic.com/services/oil-level-is-low-inspection). If the car was overheated and potentially has developed a blown head gasket, this may be possibly what have caused the stall. When this happens, the cylinder...

Battery light on while driving but then goes off?

The battery light indicates that your charging system has a flaw in it which may be a sign of a weak battery, a failing voltage regulator or failing alternator. As you may know, the alternator is responsible for charging the...

Replacing just the AC compressor and belt

If the compressor is replaced, the only mandatory component to change is the system drier. If the belt is worn or old, it should be replaced. Replacement of any and all other parts is simply subject to a diagnostic and...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com