Mitsubishi Eclipse Engine is misfiring Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(450)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(450)

Engine is misfiring Inspection Service

How much does a Engine is misfiring Inspection cost?

On average, the cost for a Mitsubishi Eclipse Engine is misfiring Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1998 Mitsubishi EclipseL4-2.4LService typeEngine is misfiring InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1996 Mitsubishi EclipseL4-2.4LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1993 Mitsubishi EclipseL4-2.0L TurboService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2005 Mitsubishi EclipseV6-3.0LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1998 Mitsubishi EclipseL4-2.0L TurboService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2002 Mitsubishi EclipseL4-2.4LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1999 Mitsubishi EclipseL4-2.4LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1994 Mitsubishi EclipseL4-1.8LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Mitsubishi Eclipse Engine is misfiring Inspection prices

When an engines misfires, it’s usually readily apparent to the driver from the stuttering and jerking produced by the engine when one or more cylinders fails to fire properly, either because of ignition- or fuel-related issues. It is accompanied by a loss of power in direct proportion to the severity of the misfire.

It can be tricky for to track down the problem if the misfire only occurs under certain circumstances, for example, under load. Not all misfires occur across the operating spectrum.

For older vehicles:

On older, carbureted vehicles, the culprit will almost certainly be in the ignition system as older vehicles lack many of the sophisticated sensors that can cause a misfire. A vacuum leak or a faulty fuel pump can also cause this symptom as well. The first thing the mechanic will do is determine which cylinder or cylinders is misfiring, and the spark plug color is probably the best way to tell. The guilty plug will most likely be grayer than the others, which should tend toward brown coloring. If needed, the spark plug can be replaced.

The next step would be checking the wiring to that plug for cracks and deterioration, and replace as necessary.

For most modern vehicles:

In modern cars, misfiring will invariably be accompanied by a Check Engine light. In fact, checking for efficient combustion was the primary reason the U.S. government introduced the rules for OBD-II (on-board diagnostics, second generation). It was part of the push toward cleaner exhaust emissions.

A code reader will tell you which cylinder is to blame, but it may not say whether it is a problem relating to the injector serving that cylinder or the systems delivering the ignition spark. As with older vehicles, a look at the wires and spark plugs is a good idea. Checking them in the dark will sometimes reveal errant spark tracking, as will spraying them with a fine water mist.

One way mechanics check which spark plug is failing to hold its own is by running the engine at an idle speed high enough to produce the misfire, then removing leads from the coilpack (the unit that looks like the distributor we are used to seeing in older vehicles ) one by one. Most removals will cause a profound change in idling performance, but a defective wire will not. That will suggest that it’s either the spark plug or the coil serving that cylinder at fault. If a new spark plug at that cylinder does not remove the stumble, the mechanic may need to replace the coil pack or the wires as a set.

If it isn’t an ignition issue, then the injectors will need to be checked. A mechanic uses a multimeter to check the resistance value at each injector. It may be a bit difficult to reach them, sometimes requiring the removal of an engine cover and the intake manifold. The mechanic disconnects the injector, then touches the multimeter probes to the two connector prongs to read the value, in Ohms. If any of the injectors read outside of the specified values, they will need to be replaced.

Along the same lines, a fuel pump starting to go bad can also cause misfires or similar issues and can be diagnosed with a fuel pressure check of the entire system with the appropriate equipment. This should only be done by a qualified mechanic as the fuel system is highly pressurized and of course, fuel is flammable.

Common reasons for this to happen:

  • Faulty spark plugs or wires
  • Faulty ignition coil
  • Broken piston rings
  • Burnt or bent valves
  • Broken valve springs
  • Camshaft worn out
  • Fuel injector is not working

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the misfiring engine, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How important is this service?

A misfiring engine is accompanied by a loss of power, which makes this issue a critical one to correct promptly. Book a mechanic to perform a thorough inspection as soon as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mitsubishi mechanics

Real customer reviews from Mitsubishi owners like you.

Excellent Rating

(450)

Rating Summary
425
13
2
2
8
425
13
2
2
8

Angel

28 years of experience
118 reviews
Angel
28 years of experience
Mitsubishi Eclipse V6-3.0L - Engine is misfiring - Mesa, Arizona
Trustworthy, did a complete and comprehensive inspection of my car. Will use again!

Mike

28 years of experience
35 reviews
Mike
28 years of experience
Mitsubishi Eclipse L4-2.4L - Timing Belt - Spring, Texas
Mike did a fantastic job on my Mitsubishi Eclipse.He was professional, explain the problems with my car and fixed it without breaking a sweat. He's a life saver, I don't know what I would've I done if it wasn't for him. Thanks again Mike.

Whitney

39 years of experience
783 reviews
Whitney
39 years of experience
Mitsubishi Eclipse L4-2.4L - Oil Change - San Mateo, California

Ben

41 years of experience
1416 reviews
Ben
41 years of experience
Mitsubishi Eclipse L4-2.4L - AC is not working - Houston, Texas
Professional, knowledge, efficient ! Was very confident and comfortable with his diagnosis, repair and inspection.

Excellent Rating

(450)

Rating Summary
425
13
2
2
8
425
13
2
2
8
Number of Mitsubishi Eclipse services completed
4950+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mitsubishi MECHANICS
700+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Throttle Body
Common signs include dirt, grime, and carbon deposits on the inside of the housing, electrical problems, vacuum leaks, and a very poor or high idle.
How to Get a Minnesota Driver's Permit
Minnesota Minnesota uses a graduated driver’s license program, like many other states. This program requires all new drivers under 18 years old to begin driving under supervision, in order to practice safe driving before getting their full driver’s license. In...
P2272 OBD-II Trouble Code: O2 Sensor Signal Stuck Lean Bank 2 Sensor 2
What What the P2272 code means? P2272 is an OBD-II generic code for the engine control module (ECM) detecting the O2 sensor for bank 2 sensor 2 after the catalytic convertor is stuck lean. What causes the P2272 code? The...

When raining, brakes grind first few stops and then clear up

The brake pads have metal in them, and the rotors are made of metal, and when it rains they get wet and surface rust will immediately start to rust the rotors. As soon as you start to drive off, the...

White smoke coming out of hood when idle / stopped

This sounds unfortunately like a blown head gasket problem. The fluctuation in temperature and white smoke is usually a sign of this. I would suggest having the coolant tested for traces of combustion gases which will indicate if the head...

I’m having trouble with my 2006 [sonata](/topics-sonata/) with a 3.3 v6 automatic. Heavy vibrations when in drive or reverse( low speeds or stopped only) brake pedal becomes very stiff and there’s a whistling clicking sound. Any ideas?

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com