Mercedes-Benz R550 Exhaust Manifold Repair at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(6,334)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(6,334)

Exhaust Manifold Repair Service

How much does a Exhaust Manifold Repair cost?

On average, the cost for a Mercedes-Benz R550 Exhaust Manifold Repair is $1178 with $534 for parts and $644 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 Mercedes-Benz R550V8-5.5LService typeExhaust Manifold RepairEstimate$1781.74Shop/Dealer Price$2077.91 - $2901.20
Show example Mercedes-Benz R550 Exhaust Manifold Repair prices

What is the Exhaust Manifold all about?

Depending on your engine and type of vehicle, the exhaust manifold can either be a set of pipes or it can be a cast iron manifold assembly. Essentially the exhaust manifold takes the burned exhaust gases from the engine’s cylinders and ejects the gas through the exhaust system and out through the car's tail pipe. The exhaust gases are the burned fuel/air residue from the combustion process in the cylinders of the engine. Over time, the constant expansion and contraction of the components (caused by constant heating and cooling in the engine), may cause the manifold to crack and leak. These leaks can be hazardous as hot exhaust gases escape and can damage other components in the engine compartment. A leaky exhaust manifold can also impact engine performance.

Keep in mind:

Sometimes an exhaust manifold starts to leak because a mounting bolt has broken. If this happens, the mechanic will have to remove the broken bolt or stud, which can increase the labor time needed to fix the problem. Your mechanic may charge you an additional fee, depending on the severity of the situation.

How it's done:

  • Determine if the manifold is cracked or broken.
  • Remove and replace faulty exhaust manifold.
  • Inspect exhaust studs, clean carbon and old gasket off cylinder head.
  • Install new gasket and exhaust manifold.
  • Start engine and check for exhaust leaks.

Our recommendation:

The exhaust manifold is transferring burned gasses from the engine. It is located in a high temperature zone, and it will leak eventually. There is no way to prevent it. Your mechanic should use anti-seize compound on the bolts when they are replacing this part. This will help prevent bolts from breaking in the cylinder head.

What common symptoms indicate you may need to replace the Exhaust Manifold?

  • Loud noise from engine.
  • Lack of engine performance.
  • Check engine light is on.
  • Smells from the engine compartment (eg. plastic components next to exhaust manifold melting from escaped heat).

How important is this service?

A leaky exhaust manifold is a health and safety concern. Hot exhaust gases escaping from the engine can be a fire hazard melting nearby plastic components in the engine compartment.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(6,334)

Rating Summary
5,908
202
59
31
134
5,908
202
59
31
134

Whitney

40 years of experience
783 reviews
Whitney
40 years of experience
Mercedes-Benz S420 V8-4.2L - Fix a Flat Tire (Plug Holes) - Palo Alto, California
It's great.

Trevor

23 years of experience
185 reviews
Trevor
23 years of experience
Mercedes-Benz 190E L4-2.3L - Car does not move when I step on the gas pedal - San Diego, California
Treavor worked diligently to find the cause of my problem, but was unable to pinpoint what was causing my 190E to not accelerate properly. He suggested that the O2 sensor may be in the wrong location, after my Catalytic converter was replaced, and pre-cats were gutted. I have since confirmed that the sensor is located properly, so may just need to replace the O2 sensor. My dilemma continues.

Brian

24 years of experience
818 reviews
Brian
24 years of experience
Mercedes-Benz E320 V6-3.2L - Car is making a noise - Jacksonville, Florida
Appt set...called and came 2-3 hrs ahead of time....husband greeted...professional looking....did 50pt inspection mostly in rain....knowledgeable and honest in evaluations quotes for repairs etc.....best service had during my 4 years of ownership of Benz....will be calling upon Brian again to do applicable repairs in near future....Great service and mechanical expertship

Kelly

35 years of experience
173 reviews
Kelly
35 years of experience
Mercedes-Benz C300 V6-3.5L - Oil Change - Charlotte, North Carolina
Did appreciate Kelly not being on time due to having to get supplies. Service was quicker than going to the dealer.

Excellent Rating

(6,334)

Rating Summary
5,908
202
59
31
134
5,908
202
59
31
134
Number of Mercedes-Benz services completed
69674+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Drive Long Distances Alone
When When going on a long trip (https://www.yourmechanic.com/article/seven-tips-for-planning-the-great-american-road-trip-by-kevin-woo) in your vehicle, it is best to take someone with you to help with driving duties and to help you stay awake. Unfortunately, this is not always possible, mainly due to scheduling...
P2262 OBD-II Trouble Code: Turbo Boost Pressure Not Detected - Mechanical
P2262 code definition Turbo Boost Pressure Not Detected-Mechanical What the P2262 code means P2262 is an OBD-II generic code. The engine control...
How to Register a Car in West Virginia
Getting Getting a car registered is an important part of staying in compliance with state laws. If you are new to West Virginia, you will need to make sure that registering your vehicle with the DMV is at the top...

Water in the tail light which rusted sockets

The warning lights for the bulbs are very sensitive, as they look for the proper resistance in the tail light and brake light bulbs. When water gets into the tail light housing like this, it generally means the tail light...

Feels like it has no power

Generally, the "symptom" you are describing reflects an ignition and/or fuel system issue including all of the many sensors that control these systems. An expert would use any DTC's (diagnostic trouble codes) to hone in on the issue and identify...

1991 Chevy S10 cranks but won't start. Replaced distributor,fuel pump, and ecu. Injectors will not pulse

You most likely have a bad ignition spark control module.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com