Mercedes-Benz R320 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Mercedes-Benz R320 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2007 Mercedes-Benz R320V6-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2008 Mercedes-Benz R320V6-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2009 Mercedes-Benz R320V6-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example Mercedes-Benz R320 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5)

Rating Summary
3
2
0
0
0
3
2
0
0
0

Tung

16 years of experience
310 reviews
Tung
16 years of experience
Mercedes-Benz R320 V6-3.0L Turbo Diesel - Exhaust Gas Recirculation (EGR) Tube - Marietta, Georgia
Tung worked hard and got the job done! Highly recommended.

Chris

16 years of experience
332 reviews
Chris
16 years of experience
Mercedes-Benz R320 V6-3.0L Turbo Diesel - Serpentine/Drive Belt - Spring Valley, California
Friendly

Ben

41 years of experience
1436 reviews
Ben
41 years of experience
Mercedes-Benz R320 V6-3.0L Turbo Diesel - Oil Change - Katy, Texas

Arturo

27 years of experience
303 reviews
Arturo
27 years of experience
Mercedes-Benz 300D L6-3.0L Turbo Diesel - Car starts and then dies - San Diego, California
Arturo knows what he is doing.He is an asset to your company

Excellent Rating

(5)

Rating Summary
3
2
0
0
0
3
2
0
0
0
Number of Mercedes-Benz Car starts and then dies Inspection services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How the Starter Works in Your Car
A A car starter is a powerful electric motor that cranks your engine in order to start your car. The starting system consists of the motor itself, and the attached solenoid. The solenoid is what takes battery power and delivers...
How to Choose a LoJack System For Your Car
LoJack LoJack is the trade name for a radio transmitter technology system that allows vehicles to be tracked if they have been moved unwantedly, or have been stolen. LoJack’s trademark technology is the only one on the market used directly...
Disabled Driver Laws and Permits in West Virginia
Types Types of placards and plates The State of West Virginia offers various parking permits for people with disabilities. They include: Permanent placards Permanent license plates Temporary placards Applying If you have a qualifying disability in the State of West...

2007 Dodge Grand Caravan hard detonation problems

Take a compression tester and check the compression of each cylinder. This will determine how much pressure will hold in the cylinders. If the pressure is 120 or higher, then the cylinders are okay. If the pressure is lower than...

Fuel gauge reads empty way too soon.

Hi there. The diagnoses and repair for the inaccurate fuel gauge should be entirely covered by the manufacturer's warranty. They have three chances to correct this problem, before it falls under the lemon law category. The most likely cause would...

Why does my Murano make a rattling noise only at the beginning when I start the vehicle?

Hello, thank you for writing in. Typically on cold starts, the vehicle struggles at first to lubricate all of the engine components with the thick oil. As the engine heats up the oil thins out and becomes the viscosity the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com