Mercedes-Benz E43 AMG Brake pads are wearing out quickly Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5,730)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5,730)

Brake pads are wearing out quickly Inspection Service

How much does a Brake pads are wearing out quickly Inspection cost?

On average, the cost for a Mercedes-Benz E43 AMG Brake pads are wearing out quickly Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2017 Mercedes-Benz E43 AMGV6-3.0L TurboService typeBrake pads are wearing out quickly InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2018 Mercedes-Benz E43 AMGV6-3.0L TurboService typeBrake pads are wearing out quickly InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mercedes-Benz E43 AMG Brake pads are wearing out quickly Inspection prices

Modern disc brakes are far superior to older drum brakes in many ways. They offer better stopping power, and can be equipped with antilock technology to enhance your safety. However, they do have a few drawbacks. One of those is that pads wear out more quickly than shoes (pads are used on disc brakes, while shoes are used with drum brakes). With that being said, if you’re experiencing unusually fast brake pad wear, there could be a problem.

How this system works:

Your brake pads are the point where all the action happens with your system. They’re prone to wear and tear through normal operation. Understanding how disc brakes work isn’t all that hard, and the basics of the system are pretty simple.

A standard disc brake setup consists of a caliper, two brake pads and a rotor (per wheel). Fluid is sent to the caliper from the master cylinder when you press the brake pedal. A piston inside the caliper is activated, and the caliper then squeezes the rotor between the inner and outer brake pad. This slows down your car. It also creates friction, heat and lots of wear on the material of the brake pad.

Over time, brake pads wear out. That’s only natural. You have to replace them periodically. The exact frequency will depend on your driving style and habits. For instance, if you do a lot of stop-and-go driving, you can expect your pads to wear out much faster than a driver who does mostly highway or interstate driving.

With that being said, if you’re noticing abnormally fast brake wear, there could be some issues.

Common reasons for this to happen:

  • Driver Error: The single most common cause of abnormally fast brake wear is driver error. This is most usually seen with “two-footed” drivers who use their right foot to work the gas and their left to work the brake. These drivers tend to leave their left foot resting ever so slightly on the brake pedal. Understand that ANY pressure on the pedal engages the brakes. So, even a small amount of pressure on the corner of the pedal is enough to put the pads in contact with the rotor while the car is moving. This eats through pads very quickly. It’s also generally accompanied by “bluing” of the rotors, which is a sign of overheating.

  • Corroded Slide Pins: The caliper must be able to slide smoothly and evenly at all times. If the slide pins are corroded (most common on old cars, or flood-damaged vehicles), the caliper may not slide out evenly, leaving it sitting slightly off center. This keeps part of the pad in contact with the rotor at all times and will result in premature pad replacement.

  • Abnormal Rotor Wear: In a normal brake system, the surface of the rotor should be smooth, and both sides should be an equal thickness. However, if the rotors are worn, grooved, pitted, burnt or have seen significant wear (and are now in need of replacement), they can create rapid pad wear. It can also cause brake pads to crack, wear strangely (grooving) and other problems.

  • Using Cheap Pads: You’ll find replacement pads available for a wide range of prices, and the natural inclination is often to go for the lower priced option. However, cheap pads generally don’t wear very long. In addition, some very cheap pads can contain chunks of metal that will eat into your rotors. Avoid low-quality pads, even if it means paying a little more.

  • Torn Piston Seal: Pistons are operated by brake fluid, but if the seal is broken, fluid will leak out. Additionally, the piston will not be able to return to its starting position completely, maintaining some degree of contact between the pads and the rotor, accelerating wear significantly.

What to expect:

A top-rated mobile mechanic will come to your home or office to inspect the entire braking system, including the seals, pads, rotors, calipers, pistons, slide pins and more. The mechanic will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will visually inspect the disc brakes to verify both their condition and system operation. This will include the lines, the calipers, the pistons, brake pads, rotors and more. It may be necessary to jack the car up in order to remove the wheels for a full inspection of the system.

How important is this service?

If your brake pads are wearing out prematurely, it can be expensive, frustrating and dangerous. Without reliable brakes, your car is not safe to drive. Your brakes should be inspected during routine maintenance, and you should be aware of their condition at all times. One of our professional mechanics can inspect your brake system and advise you on what needs to be done to repair the issue.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5,730)

Rating Summary
5,332
192
54
29
123
5,332
192
54
29
123

Rodney

36 years of experience
561 reviews
Rodney
36 years of experience
Mercedes-Benz C320 V6-3.2L - Brake pads are wearing out quickly - Sacramento, California
On time. Explained everything. Very proffessional.

Robert

12 years of experience
76 reviews
Robert
12 years of experience
Mercedes-Benz S550 V8-5.5L - Oil Change - San Jose, California
He is thorough and courteous. He takes time to work on my car.

Tien

23 years of experience
903 reviews
Tien
23 years of experience
Mercedes-Benz E55 AMG V8-5.5L - Oil Change - Alameda, California
Thanks for coming by and doing a great job!

David

16 years of experience
637 reviews
David
16 years of experience
Mercedes-Benz C230 V6-2.5L - Car is making a noise - Carmichael, California
David was very knowledgeable and very professional.

Excellent Rating

(5,730)

Rating Summary
5,332
192
54
29
123
5,332
192
54
29
123
Number of Mercedes-Benz services completed
63030+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Brake Caliper
Common signs include brake fluid leaks, abnormal sounds, and vehicle pulling to the left or right.
Mercury Certified Pre-Owned (CPO) Car Program
Drivers Drivers who are shopping around for a used Mercury vehicle may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on to...
10 Best Stores to Buy Auto Parts in Kansas City, Missouri
Automotive technicians rely on auto parts stores to add and replace car parts. The best auto parts shop in Kansas City is O’Reilly Auto Parts.

Passenger side seat belts getting stuck.

Hi, The seat belt system is designed to lock if pulled out too fast or if in a fast stop. Inside the mechanism for the belt there is a ratching mechanism that controls this locking and is not serviceable at...

Ignition fuse keeps blowing, all back lights don't work, gauges messed up, can't shift out of park when engine is on.

The ignition switch is damaged and needs replaced. The contacts inside the ignition switch is are shorting out with itself. This is why the switch has to be in a specific position to release the shift interlock solenoid. If you...

When I come to a slow stop, my car starts rocking back and forth.

Typically this type of concern would come from bad misfires as the engine and transmission internals are likely the only parts of the vehicle in motion while you are stopped. Misfires would normally cause a check engine light so you...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com