Mazda Protege Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(162)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(162)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Mazda Protege Power Steering Pump Replacement is $370 with $216 for parts and $154 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1997 Mazda ProtegeL4-1.5LService typePower Steering Pump ReplacementEstimate$877.98Shop/Dealer Price$1058.81 - $1592.39
2003 Mazda ProtegeL4-1.6LService typePower Steering Pump ReplacementEstimate$740.71Shop/Dealer Price$880.82 - $1295.80
2002 Mazda ProtegeL4-2.0LService typePower Steering Pump ReplacementEstimate$974.17Shop/Dealer Price$1172.68 - $1762.78
1994 Mazda ProtegeL4-1.8LService typePower Steering Pump ReplacementEstimate$637.27Shop/Dealer Price$748.09 - $1074.70
1997 Mazda ProtegeL4-1.8LService typePower Steering Pump ReplacementEstimate$868.07Shop/Dealer Price$1048.60 - $1581.96
2002 Mazda ProtegeL4-1.6LService typePower Steering Pump ReplacementEstimate$740.71Shop/Dealer Price$881.03 - $1296.17
2000 Mazda ProtegeL4-1.6LService typePower Steering Pump ReplacementEstimate$948.57Shop/Dealer Price$1140.70 - $1711.61
1996 Mazda ProtegeL4-1.8LService typePower Steering Pump ReplacementEstimate$868.07Shop/Dealer Price$1046.98 - $1579.12
Show example Mazda Protege Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mazda mechanics

Real customer reviews from Mazda owners like you.

Excellent Rating

(162)

Rating Summary
152
3
1
1
5
152
3
1
1
5

Travis

10 years of experience
549 reviews
Travis
10 years of experience
Protege 2002 - Wheel Bearings - Shakopee, MN
Very professional.

Travis

10 years of experience
549 reviews
Travis
10 years of experience
Protege 2002 - Radiator - Shakopee, MN
Very professional.

Jonathan

30 years of experience
503 reviews
Jonathan
30 years of experience
Protege 2000 - Thermostat - Tampa, FL
Knows his stuff. Very helpful. Time efficient.

Kenneth

8 years of experience
31 reviews
Kenneth
8 years of experience
Protege 2002 - Battery Terminal Ends - West Jordan, UT
Kenneth was able to diagnose the real issues with my car which saved me money. I appreciated his honesty. I definitely would have him back for other repairs.

Excellent Rating

(162)

Rating Summary
152
3
1
1
5
152
3
1
1
5
Number of Mazda Protege services completed
1782+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mazda MECHANICS
1100+
experts on our platform

Recent articles & questions

Test a Car Battery: Step-by-Step Guide
Keep your vehicle running smooth with this guide on how to check a car battery. Find out how to test a car battery life with YourMechanic.
How Long Does a Power Steering Hose Last?
Chances Chances are good that your car’s power steering system is hydraulic – most of them are. Electronic power steering (EPS) is becoming more common, and older, manual style systems are still out there, but hydraulic systems are by far...
How to Become a Certified Mobile Vehicle Inspector (State Car Inspector Certified) in Idaho
Automotive technician jobs include mobile vehicle inspectors. Repair facilities, dealerships, and garages can become certified to inspect vehicles.

Hearing brake noise

First the noise needs to be tracked down to the specific components or system affected. Noises can come from worn components along the suspension system. Wheel bearings or drive belt pulleys are common failure items. Brake pads will definitely cause...

Broken ignition will it start if I replace the whole steering column ?

Hello there, a few different things can cause the ignition to brake. If the ignition was broken due to a theft, then the usual repair would be to replace the ignition switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-switch) and key cylinder (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-lock-cylinder). It would be...

A/C fuse busted when car starts to run

Hello there, thank you for asking about your 2004 Honda Civic. You should try to disconnect the AC compressor and run the car as if the AC compressor is plugged in to see if the fuse blows still. If it...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com