Jaguar XJ6 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(32)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(32)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Jaguar XJ6 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1995 Jaguar XJ6L6-4.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$139.99 - $158.75
1993 Jaguar XJ6L6-4.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.04 - $138.82
1972 Jaguar XJ6L6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.03 - $138.82
1987 Jaguar XJ6L6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$119.98 - $138.72
1987 Jaguar XJ6L6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.07 - $138.89
1992 Jaguar XJ6L6-4.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.03 - $138.82
1986 Jaguar XJ6L6-4.2LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$124.69 - $143.22
1988 Jaguar XJ6L6-3.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$125.63 - $144.85
Show example Jaguar XJ6 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Jaguar mechanics

Real customer reviews from Jaguar owners like you.

Excellent Rating

(32)

Rating Summary
28
3
0
1
0
28
3
0
1
0

Richard

13 years of experience
601 reviews
Richard
13 years of experience
Jaguar XJ6 L6-4.0L - Steering Rack/Gearbox - Henderson, Nevada
Richard is the best as always! He will fix all my cars for sure!

Kyle

12 years of experience
39 reviews
Kyle
12 years of experience
Jaguar XJ6 L6-4.2L - Battery Light is on - Charlotte, North Carolina
extremely helpful and professional, felt very comfortable during the entire process

James

23 years of experience
99 reviews
James
23 years of experience
Jaguar XJ6 L6-4.2L - Fuel Pump - Douglasville, Georgia
My 1987 Jaguar would not start. James tested the fuel pump and determined a new one was needed. He replaced the fuel pump and now it starts. Great job!

Joshua

27 years of experience
709 reviews
Joshua
27 years of experience
Jaguar XJ6 L6-4.0L - Brake System Flush - Oakland, California

Excellent Rating

(32)

Rating Summary
28
3
0
1
0
28
3
0
1
0
Number of Jaguar XJ6 services completed
352+
services done by our mechanics
TOTAL NUMBER OF EXPERT Jaguar MECHANICS
400+
experts on our platform

Recent articles & questions

How Do Secondary Defoggers Work?
Your Your car is equipped with two defoggers/defrosters. The primary one is in the front, and it’s tied into your air conditioner. Turn the controls to defrost, set your temperature, and then turn on the fan and you can watch...
How To Replace a Cabin Air Filter That’s Behind the Glove Box
Cabin Cabin air filters are a new feature found on many late model vehicles. These filters are responsible for filtering the air that enters the vehicle when the heating and air conditioning (AC) systems are in use. They prevent any...
How to Get Smog Technician Certified in Oregon
Automotive technician jobs include smog certified emissions inspectors. In Oregon, the Department of Environmental Quality handles this job.

How do I adjust the volume in the infotainment system?

Adjusting the volume in the infotainment system is very easy. Simply rotate the VOL knob until you reach your volume preference. The volume will increase when the knob is rotated clockwise, and decrease when the knob is rotated counterclockwise.

I'm getting power to distributor coil, but I'm not getting power to the spark plugs.

Hi there. Check the spark plugs with a spark adapter tool to see if there is a park induced from the coil. If there is no spark, then the spark plug wires could be burned and need replaced. If the...

My car barely shifts gears, so hard to shift , now won't go into park!!

Hi there. Your car has a safety switch on the transmission that will only allow the vehicle to start in park gear with an automatic transmission. If you're having problems with the shifter, it's quite possible that either the shifting...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com