Isuzu Ascender Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(29)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(29)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Isuzu Ascender Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2003 Isuzu AscenderV8-5.3LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2004 Isuzu AscenderL6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2007 Isuzu AscenderL6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2006 Isuzu AscenderL6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2008 Isuzu AscenderL6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2003 Isuzu AscenderL6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2005 Isuzu AscenderV8-5.3LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2006 Isuzu AscenderV8-5.3LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Isuzu Ascender Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Isuzu mechanics

Real customer reviews from Isuzu owners like you.

Excellent Rating

(29)

Rating Summary
28
1
0
0
0
28
1
0
0
0

Ruben

10 years of experience
63 reviews
Ruben
10 years of experience
Isuzu Ascender L6-4.2L - Oil Change - Columbia, South Carolina
I highly recommend Ruben. He is very knowledgeable with cars. He has a great personality. I would love to continue to work with him. He did an awesome job.

Joseph

33 years of experience
540 reviews
Joseph
33 years of experience
Isuzu Ascender L6-4.2L - Variable Valve Timing (VVT) Solenoid - Plano, Texas
Great service and price!

Wilson

13 years of experience
296 reviews
Wilson
13 years of experience
Isuzu Ascender L6-4.2L - Brake Pads Replacement (Front) - Orlando, Florida
Wilson was professional, honest, and on time.

John

27 years of experience
1019 reviews
John
27 years of experience
Isuzu Ascender L6-4.2L - Wheel Bearings Replacement (Passenger Side Front) - Pearland, Texas
John was pleasant, efficient, and explained everything he was doing and why in terms a non-mechanic like myself understood. When he was delayed at his previous appointment to min e he made sure he notified me in plenty of time and kept me updated on his arrival time.

Excellent Rating

(29)

Rating Summary
28
1
0
0
0
28
1
0
0
0
Number of Isuzu Ascender services completed
319+
services done by our mechanics
TOTAL NUMBER OF EXPERT Isuzu MECHANICS
200+
experts on our platform

Recent articles & questions

How to Brake Smoothly (The Pivot Method)
Braking Braking is a skill. Braking, just like any other aspect of driving, takes a certain level of skill to get right. Good braking technique will not only be less stressful on the driver and passengers, but it will also...
How Do I Maintain My Car?
Regular Regular checks, scheduled maintenance, and a general awareness of some of the components in your car can significantly enhance the life of your vehicle and your peace of mind while driving it. Basic car maintenance usually requires keeping up...
P0439 OBD-II Trouble Code: Catalyst Heater Control Circuit
Trouble code P0439 means the catalyst heater control circuit has sent the PCM a below-acceptable voltage reading.

I have a 1982 Chrysler Lebaron Medallion 2.6l (G54b)vin D 8th digit. The engine recently went out. I found other engines that wer

The "D" in the eighth position of your VIN number designates the 2.6L engine. If your VIN has a "B" in the eighth position, that designates the 2.2L engine. Inasmuch as your vehicle was equipped with the 2.6L engine you...

Rear driver side wheel locked - 2002 Toyota Solara

If the car does move (in reverse) then the wheel is not locked. There may be an issue with the transmission and/or the shift linkage. To resolve this, please request a transmission shift diagnostic (https://www.yourmechanic.com/services/car-does-not-shift-from-park-to-drive-inspection). If you request that service,...

Do you possibly know what models/ years I could get a transmission from? tr580gd7aa

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com