Hyundai Veracruz Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(51)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(51)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Hyundai Veracruz Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2011 Hyundai VeracruzV6-3.8LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2008 Hyundai VeracruzV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2007 Hyundai VeracruzV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2009 Hyundai VeracruzV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2012 Hyundai VeracruzV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2010 Hyundai VeracruzV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Hyundai Veracruz Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Hyundai mechanics

Real customer reviews from Hyundai owners like you.

Excellent Rating

(51)

Rating Summary
50
1
0
0
0
50
1
0
0
0

Lee

38 years of experience
217 reviews
Lee
38 years of experience
Hyundai Veracruz V6-3.8L - Alternator - Oklahoma City, Oklahoma
Lee was very informative.

Garrison

9 years of experience
29 reviews
Garrison
9 years of experience
Hyundai Veracruz V6-3.8L - Axle / CV Shaft Assembly Replacement (Driver Side Front) - Owings Mills, Maryland
Garrison was on time and did an excellent job.

Brandon

20 years of experience
773 reviews
Brandon
20 years of experience
Hyundai Veracruz V6-3.8L - Serpentine/Drive Belt Replacement - Kissimmee, Florida
First time I’ve ever use she’ll he made me want to try you again gave me a estimate on additional work that I may look towards you within the next couple of weeks for very very professional

Larry

18 years of experience
27 reviews
Larry
18 years of experience
Hyundai Veracruz V6-3.8L - Brake Pads Replacement (Front, Rear) - Glen Allen, Virginia
Great job! On time, and work performed as outlined. Also nice that Larry didn't suggest any unnecessary services.

Excellent Rating

(51)

Rating Summary
50
1
0
0
0
50
1
0
0
0
Number of Hyundai Veracruz services completed
561+
services done by our mechanics
TOTAL NUMBER OF EXPERT Hyundai MECHANICS
1300+
experts on our platform

Recent articles & questions

Disabled Driver Laws and Permits in Arkansas
The The rules for obtaining disabled driver status differ by state. The following are some of the qualifications you must possess in the state of Arkansas to obtain disabled driver status. How do I know if I qualify for disabled...
P2158 OBD-II Trouble Code: Vehicle Speed Sensor 'B'
P2158 P2158 code definition Vehicle Speed Sensor 'B' What the P2158 code means This trouble code indicates that the powertrain control module has detected a variation in the reference voltage of the vehicle speed sensor 'B' in reference to the...
How to Replace an AC Clutch Cycling Switch
An AC clutch cycling switch meters low side AC pressure. This switch helps the AC system maintain proper cabin and evaporator temperatures.

Clutch shifts hard

Hello! From your description, it sounds as if you have a hydraulic issue. I suggest that a technician drive the vehicle to perform a clutch performance test. The clutch performance test will help indicate whether the clutch itself is faulty, or...

What would cause 2 main computers to be bad within 6months

This does sound like a very frustrating experience. Unfortunately it is difficult to pinpoint exactly what is causing your computer to go bad (https://www.yourmechanic.com/article/how-long-does-an-engine-control-module-ecm-last) without knowing what kind of computers have been installed in your vehicle. Aftermarket, used or refurbished...

Loss of power my tool says map sencors is bad burning rich

Hello and thank you for contacting YourMechanic. If the engine light is on for code P0105, then the computer has lost communication from the MAP (Manifold Absolute Pressure) sensor. Check the harness to the sensor for any corrosion and look...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com