Audi allroad Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

customer ratings

(10)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

customer ratings

(10)

Car Battery Replacement Estimate for Audi allroad

Audi allroad Car Battery Replacement costs $336 on average.

CarServiceEstimateShop/Dealer Price
2013 Audi allroadL4-2.0L TurboService typeCar Battery ReplacementEstimate$584.31Shop/Dealer Price$732.39 - $1121.51
2015 Audi allroadL4-2.0L TurboService typeCar Battery ReplacementEstimate$574.31Shop/Dealer Price$719.62 - $1106.66
2014 Audi allroadL4-2.0L TurboService typeCar Battery ReplacementEstimate$574.31Shop/Dealer Price$719.62 - $1106.66
2016 Audi allroadL4-2.0L TurboService typeCar Battery ReplacementEstimate$574.31Shop/Dealer Price$719.58 - $1106.59
Show example Audi allroad Car Battery Replacement prices

Car Battery Replacement Service

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Audi mechanics

Real customer reviews from Audi owners like you.

Excellent Rating

(10)

Rating Summary
10
0
0
0
0
10
0
0
0
0

Joseph

20 years of experience
597 reviews
Joseph
20 years of experience
Audi allroad L4-2.0L Turbo - Cabin Air Filter - Salt Lake City, Utah
Joseph was very helpful and gave me a professional opinion about the quality of my car and the future services it would require. It was my first experience with YourMechanic and I will definitely be using the service (and Joseph) again!

Lucas

21 years of experience
885 reviews
Lucas
21 years of experience
Audi allroad L4-2.0L Turbo - Squealing noise from brakes - Santa Monica, California
Lucas was very knowledgeable and patient in investigating the problem and explaining and following up on the situation. Another great YOur Mechanic experience!

Corey

16 years of experience
11 reviews
Corey
16 years of experience
Audi allroad L4-2.0L Turbo - Brake System Flush - Portland, Oregon
Great experience, arrived in time and completed the job with care and attention to detail. Highly recommended

Lucas

21 years of experience
885 reviews
Lucas
21 years of experience
Audi allroad L4-2.0L Turbo - Oil Change - Woodland Hills, California
Very good and informative. He did miss the appointment time but delivered a fair explanation for the delay.

Excellent Rating

(10)

Rating Summary
10
0
0
0
0
10
0
0
0
0
Number of Audi allroad services completed
110+
services done by our mechanics
TOTAL NUMBER OF EXPERT Audi MECHANICS
700+
experts on our platform

Recent articles & questions

How to Clean Car Floor Mats
Whether rubber or cloth, clean car floor mats to give your vehicle a new, fresh look.
How to Replace a Car Pitman Arm
The pitman arm links the steering wheel and steering box to your vehicle's tires. A bad pitman arm can lead to poor steering or even steering failure.
How to Remove a Stuck Cylinder Head Bolt
Head bolts on the cylinder get stuck and must be removed using a breaker bar, applying impact force, or by carefully drilling the bolt out.

I have a 2003 Toyota Highlander and topped off just alittle red antifreeze today to my green antifreeze. I do not think that is ok... what should I do to fix that?

2008 Acura Swab links replacement. How much ?

Hi Krupali. Thanks for contacting us today. If you're needing the stabilizer bar links replaced (sway bar) on your Acura, and looking for an estimate, please click this link to request a quote. Thanks.

Error code p0101 and p2177 on 2008 Volvo s60 indicate the MAD AT could there be another problem?

Hello, thank you for writing in. Both codes relate to some kind of air leak. This may mean the MAF sensor has failed and is not capable of sending the signal for that air, or it may be an actual...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com