Showing articles & questions for topic
MX-5 Miata

Related questions

Question
Replaced master cylinder, bled all four sides pedal still goes to floor HELP 馃様
If you have clean brake fluid at the wheels after following the proper bleed sequence, I would try bench bleeding the master cylinder one more time and bleeding at the wheels afterwards. If you still don't have a proper brake...
Question
I need to isolate my intake from the PCV system
Hello. A high end catch can with a substantial stainless baffle will catch the oil vapors, as well as water, so there is no reason it or indeed sequential cans if you want to improve oil removal efficiency can't be...
Question
I would like to add a supercharger
Hello and thank you for contacting YourMechanic. When it comes to beefing up an engine, a supercharger is a good way to do so. When deciding on what supercharger you would need, first you need to know is that your...
Question
Will the Ford L8 Duratec engine fit in a MX5 Mk3?
Hi there. The Ford engine will not bolt up to your Mazda transmission, however, you can purchase a conversion plate that would allow the engine to bolt up to the transmission. If you do this, you will need to get...
Question
Sport car's soft top at roof line is tearing
Unfortunately, soft tops on convertibles are prone to needing replacement every few years. The point where it is tearing is likely a stress point or where the latches are located. It is not unusual to have to replace soft tops...
Question
Convertible test drove fine but now has rough ride
Many different components can attribute to a rough ride. The most common would be the tires, struts, shocks, springs, and various suspension components. A qualified technician such as one from YourMechanic will be able to diagnose why your car is...
Question
Loud low groaning/creaking noise when making turns at slow speeds
This type of low pitched noise tends to be caused by wheel bearings that are just beginning to wear out, or a CV joint that might be losing lubrication as well. It could also indicate a problem with tie rods...
Question
Code p0421, but new catalytic converter installed. Worried it's placed too far back in the system.
Hi there. Due to the fact that you've completed aftermarket alterations to your Mazda, you are likely going to continually have error code problems as you've indicated. The ECU is calibrated to receive data from OEM designed exhaust systems. Since...
Question
what modification i need tot do to place ford engine duratec 1.8 L QQDB form a ford focus 2 on the 2007 mx 5
If the engine you are attempting to use, and its accompanying complement of sensors and controls, is not listed in the catalog as a direct interchange, the problem you are facing is the engine computers of the two engines (PCM/ECM)...

Need a mechanic?

Our certified mobile mechanics make house calls in over 700 U.S. cities. Fast, free online quotes for your car repair.

Get a quote

Post a question and get free advice from our certified mechanics.


Ask a question