Volkswagen Fox Brake Drum Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Brake Drum Replacement Service

How much does a Brake Drum Replacement cost?

On average, the cost for a Volkswagen Fox Brake Drum Replacement is $466 with $171 for parts and $294 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1989 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$703.95	Shop/Dealer Price$821.82 - $1105.69
1992 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$637.21	Shop/Dealer Price$753.95 - $1034.30
1990 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$640.75	Shop/Dealer Price$758.37 - $1041.37
1993 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$637.21	Shop/Dealer Price$753.88 - $1034.17
1991 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$637.21	Shop/Dealer Price$754.00 - $1034.38
1988 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$736.94	Shop/Dealer Price$864.88 - $1156.30
1987 Volkswagen FoxL4-1.8L	Service typeBrake Drum Replacement	Estimate$757.44	Shop/Dealer Price$884.82 - $1175.82

Show example Volkswagen Fox Brake Drum Replacement prices

What are brake drums and how do they work?

A brake drum is a heavy, cast iron brake system part that looks like a shallow, several inches-high cylinder about 9 to 12 inches in diameter. The brake drum has a precisely machined surface all around the interior circumference, that the brake shoes make contact with when you apply the brakes, transmitting hydraulic pressure through the wheel cylinder. This forces the brake shoes outward against the interior of the brake drum, resulting in the friction that causes the car to slow. The brake drum is mounted over, and fully encloses, all of the rear brake components such as the wheel cylinder, springs and clips, brake shoes, and parking brake mechanism. The drum is commonly held to the wheel hub by the wheel and the lug nuts, but some configurations combine the drum with the wheel hub as one unit. Nowadays, a drum brake type system is only installed on the rear axle, if used at all, as 4 wheel disc type systems have become more common.

When to consider replacing brake drums:

Reduced braking effectiveness. If the brake drum is unevenly worn, scored or cracked, it will increase stopping distances. A cracked drum must be replaced outright but a worn drum can be restored on a brake lathe so long as enough metal material remains.
Pulsating brakes, pulling to one side, vibration or noise. If a brake drum is warped, is unevenly worn, or perhaps the brake shoes have worn down completely — creating metal-to-metal contact — you might detect pedal pulsation, the vehicle may pull to one side, or you might feel a vibration or hear a noise when you apply the brakes. The brake system will have to be inspected to pinpoint the exact problem.
Brake shoe replacement. Anytime the brake shoes are replaced, the drum must either be resurfaced or replaced outright. Installing new brake shoes on a used, unresurfaced drum will lead to poor results.
Loss of parking brake function. The parking brake locks the brake shoes against the brake drum. If the brake drum is cracked, the parking brake lever will pull up excessively and the car may still be able to roll. However, a more common circumstance is parking brake maladjustment or seizure of parking brake components. Repair of those problems will often require removal of the brake drum.

How do mechanics replace brake drums?

There are two options when it comes to brake drum service: outright replacement or resurfacing. In some cases, it is cheaper to replace the drum rather than refurbish it. In both cases though, the removal and installation procedure for the drum is the same.

Raise the vehicle and safely support it using steel jack stands.
Remove tire and wheel assembly.
Remove brake drum. Sometimes the brake drum has rusted to the wheel hub and removal of the drum will require a brake drum puller. In some cases, the wheel hub is integral to the brake drum, in which case the hub-bearing retaining bolt and the wheel bearing must be removed to replace the drum.
Measure the interior diameter of the machined surface in the drum with a brake drum micrometer or similar measuring tool. If sufficient metal exists to resurface the drum on a brake lathe, the mechanic will compare the cost of such restoration to the alternative: buying a new drum.
Prior to installing the resurfaced or new drum, the brake shoes, springs, wheel cylinder, parking brake mechanism, and backing plate are all inspected. All worn parts should be replaced. Generally, if drums have been replaced or resurfaced, new brake shoes should be installed. The worn shoes will cause irregular wear in the brake drum and reduce braking effectiveness.
The shoes are adjusted and the drum is installed. The wheel and tire assembly are installed and torqued in the proper sequence and the car is road tested to check the operation of the brakes.

Is it safe to drive with a brake drum problem?

No. Should there be a deficiency with the brake drums, stopping distances will not be as short as possible. In a panic stop, stopping just five or ten feet shorter could be the difference between no collision and a collision. Any deficiency in a vehicle’s braking system is a cause for concern and a potential safety issue. Have the brake drums inspected at your earliest convenience to determine if a problem exists and find out what must be done to fix it.

When replacing brake drums keep in mind:

With few exceptions, brake work on one end of an axle should be performed on both ends of the axle. Should a brake drum on one end of a front or rear axle be serviced, or brake shoes on one end are serviced, both sides of the axle should receive the same service. This helps to avoid problems, such as pulling, vibration, and so forth, once the vehicle is returned for use.
Brake drum systems use very powerful springs to keep the brake shoes in position. These springs are exposed to extreme heat. It is best practice to replace all springs whenever new shoes are installed. Should a spring unexpectedly break in the brake drum assembly, a mispositioned brake shoe could cause the brakes to grab and lock, which would pose a safety issue.
If the wheel hub and bearing are integral to the brake drum on your car, the mechanic may recommend replacement of the grease in the wheel bearings and inspection of the wheel bearings.
Since the arc of the brake shoes will not perfectly match with the arc of the drum when new, expect a bed-in period before maximum braking efficiency is achieved.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Volkswagen mechanics

Real customer reviews from Volkswagen owners like you.

Excellent Rating

(3)

Rating Summary

3

0

0

0

0

3

0

0

0

0

SEE REVIEWS NEAR ME

Rodney

36 years of experience

542 reviews

Rodney

36 years of experience

by Jonathan

Volkswagen Fox L4-1.8L - Brake System Inspection - Sacramento, California

Rodney arrived on time for the appointment and was able to diagnose the problem with my car almost immediately. He delved deeper into the area the problem was just to make sure, and his initial diagnosis was correct. He was very friendly and capable, and I look forward to booking his services for any car troubles I have in the future.

Berchel

18 years of experience

101 reviews

Request Berchel

Berchel

18 years of experience

Request Berchel

by Lori

Volkswagen Jetta L5-2.5L - Brake Drum - Bel Air, Maryland

Berchel is very professional, right on schedule and job was completed in a timely manner. I will definitely book service again in the near future.

Nikolay

20 years of experience

62 reviews

Request Nikolay

Nikolay

20 years of experience

Request Nikolay

by Ty

Volkswagen EuroVan L5-2.5L - Brake Drum - San Diego, California

Nikolay was exceptional! My Eurovan had a ton of small issues that he had to work through. He was detailed and patient. Would recommend him to anyone, very intelligent. Thank you Nikolay, I will be hiring you again!

Richard

11 years of experience

450 reviews

Request Richard

Richard

11 years of experience

Request Richard

by Arthur

Volkswagen Jetta L5-2.5L - Brake Drum - Capitol Heights, Maryland

Richard was actually early for our appointment. He was friendly. Richard went out of his way to explain what he was doing and even took the time to educate me about my car. Positive attitude.

Excellent Rating

(3)

Rating Summary

3

0

0

0

0

3

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

Top 10 Scenic Drives in Oregon

Oregon may not get a lot of press as a vacation destination, but that doesn’t mean it is devoid of things to see and do. In fact, the opposite is the case because this state is full of natural and...

Cell Phones and Texting: Distracted Driving Laws in Idaho

Idaho Idaho defines distracted driving is anything that diverts your attention away from focusing on driving. This includes electronic distractions as well as interacting with passengers. The Idaho Transportation Department has placed these distractions into three categories: Visual Manual Cognitive...

P2504 OBD-II Trouble Code: Charging System Voltage High

P2504 P2504 code definition The P2504 OBD-II fault code simply means that an irregularity was detected in the charging system circuit - specifically that the voltage was high. This high voltage reading may have originated from the battery, charging system,...

Car won't turn off; can't get key out of ignition

If your car is not turning off, and you are unable to remove the key, that may be sign that the ignition lock, or possibly switch, has gone bad. A failed ignition lock or switch can sometimes fail, and jam...

Power steering goes out

Hello. Your vehicle could have one of two power steering systems. If you have a traditional power steering system, with a power steering pump, power steering hoses, and rack and pinion, a malfunction of any of those components could be...

02 nissan altima. I have got the Maf and fuel pump replaced. The car starts but when I drive it after going 50mph it doesnt go up.

Claimed by Kevin Gainer

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com