Mercedes-Benz GLE550 Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(388)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(388)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Mercedes-Benz GLE550 Car Battery Replacement is $357 with $263 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2017 Mercedes-Benz GLE550V8-4.7L TurboService typeCar Battery ReplacementEstimate$639.99Shop/Dealer Price$781.24 - $1182.49
2016 Mercedes-Benz GLE550V8-4.7L TurboService typeCar Battery ReplacementEstimate$619.99Shop/Dealer Price$761.26 - $1162.52
2018 Mercedes-Benz GLE550V8-4.7L TurboService typeCar Battery ReplacementEstimate$619.99Shop/Dealer Price$761.26 - $1162.52
Show example Mercedes-Benz GLE550 Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(388)

Rating Summary
374
9
1
1
3
374
9
1
1
3

Mario

20 years of experience
110 reviews
Mario
20 years of experience
Mercedes-Benz CLK500 V8-5.0L - Battery - Cape Coral, Florida
Great person and mechanic!

Patrick

33 years of experience
1408 reviews
Patrick
33 years of experience
Mercedes-Benz C230 V6-2.5L - Car Battery Replacement - Austin, Texas
Very astute person ,great diagnostic ability

Eduardo

19 years of experience
549 reviews
Eduardo
19 years of experience
Mercedes-Benz C250 L4-1.8L Turbo - Battery - Houston, Texas
Great,on time and dependable

Breck

20 years of experience
681 reviews
Breck
20 years of experience
Mercedes-Benz C300 V6-3.0L - Battery - Spring, Texas
Breck called to let me know he had finished the job before mine ahead of schedule, so he would arrive early. Which he did. He immediately got to work and installed a new battery in no time! He was very professional and great to work with!

Excellent Rating

(388)

Rating Summary
374
9
1
1
3
374
9
1
1
3
Number of Mercedes-Benz Car Battery Replacement services completed
4268+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How Do Secondary Defoggers Work?
Your Your car is equipped with two defoggers/defrosters. The primary one is in the front, and it’s tied into your air conditioner. Turn the controls to defrost, set your temperature, and then turn on the fan and you can watch...
How to Replace a Cold Start Injector
The cold start valve fails when there is leakage coming from the fuel line. The cold start injector may have failed if the vehicle does not start.
B1909 OBD-II Trouble Code: Air Bag Crash Sensor #2 Ground Circuit Short to Ground
B1909 means there is a malfunction with the #2 airbag crash sensor circuit, most likely because of a bad electrical component or faulty sensor.

Advice on using high-mileage oil

Well, you can go ahead if you want. It's a better lubrication for old, worn rubber seals, and stuff like that. Go ahead, the oil (https://www.yourmechanic.com/article/a-guide-to-motor-oil-additives_2) is not going to hurt anything. It cost a little bit more but it's...

Why would I continue to have a P0106 code in my 2009 Ford Explorer

If you are continuing to get this code then you either got a bad sensor or you have an issue with a clog in the EGR lines. Both are common. Also, if the check engine light was not cleared after...

My car twice out of 4 times today would not start on the first time. Second time started fine. At 2 read lights it was sort of je

Hello, thank you for writing in. Your symptoms point towards an issue with fuel or spark. If you just had work done on the fuel system, you may wan to have your fuel pressure tested at the engine. This will...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com