Mercedes-Benz GL350 Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(20)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(20)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Mercedes-Benz GL350 Water Pump Replacement is $362 with $124 for parts and $238 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2014 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$1034.94Shop/Dealer Price$1196.33 - $1637.96
2016 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$495.54Shop/Dealer Price$562.84 - $752.45
2015 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$1153.61Shop/Dealer Price$1342.28 - $1886.33
2010 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$920.32Shop/Dealer Price$1070.60 - $1503.91
2013 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$920.32Shop/Dealer Price$1076.79 - $1514.74
2011 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$920.32Shop/Dealer Price$1071.19 - $1504.94
2012 Mercedes-Benz GL350V6-3.0L Turbo DieselService typeWater Pump ReplacementEstimate$920.32Shop/Dealer Price$1070.67 - $1504.03
Show example Mercedes-Benz GL350 Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(20)

Rating Summary
20
0
0
0
0
20
0
0
0
0

Chris

23 years of experience
2372 reviews
Chris
23 years of experience
Mercedes-Benz GL350 V6-3.0L Turbo Diesel - Brake Pads Replacement (Front) - Irvine, California
Great job!

Ronald

42 years of experience
519 reviews
Ronald
42 years of experience
Mercedes-Benz GL350 V6-3.0L Turbo Diesel - Power Window Switch Replacement (Driver Side Front) - Houston, Texas
Always professional and go above and beyond the call of duty!

Dustin

9 years of experience
65 reviews
Dustin
9 years of experience
Mercedes-Benz GL350 V6-3.0L Turbo Diesel - Oil Change - Houston, Texas
Professional and on time

Ronald

42 years of experience
519 reviews
Ronald
42 years of experience
Mercedes-Benz GL350 V6-3.0L Turbo Diesel - ABS Light is on - Houston, Texas
Professional and knowledgeable

Excellent Rating

(20)

Rating Summary
20
0
0
0
0
20
0
0
0
0
Number of Mercedes-Benz GL350 services completed
220+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Conduct a Pre-Purchase Inspection on a Used Car
It can be hard to know if buying a used car is a good deal. Inspect the body, tires, engine, and suspension to check if a used car is in good shape.
How to Read Tire Size From a Sidewall
You You call around, looking for a price on tires (https://www.goodyear.com/en-US/company/partner/yourmechanic?promoCode=YOURMECHANIC&utm_source=null&utm_medium=referral&partnerId=yourmechanic&partnerName=yourmechanic&retaggingLaunchUrl=%2F%2Fassets.adobedtm.com%2Flaunch-EN786b79de5697438cb1f8839bcd30487c.min.js&floodlightEnabled=true&liveChatEnabled=true&siteName=Goodyear+Tires), or maybe even brakes. The attendant on the phone asks you for your tire size. You have no idea. All you know about your tires is they are black...
Disabled Driver Laws and Permits in Arizona
Each Each state has its own rules for what you must do to receive disabled driver status. The following are some of the qualifications you must possess in the state of Arizona to receive a disabled driver placard or license...

I'm getting code po171 lean bank 1.

There vehicles are known for the intake manifold warping and having fuel injector problems at higher miles. The fuel trims can be checked while the engine is warm and spraying around the intake manifold gaskets to see if the trims...

1992 Honda Accord cooling fans not operating properly.

Hi there. Your issue is the ECT (https://www.yourmechanic.com/services/coolant-temperature-switch-sensor-replacement) sensor B is not closing the loop when engaged. There is power to the sensor A from the computer, but the sensor B is not connecting when the vehicle is running hot...

while driving, when i let completely off the gas pedal the truck kind of jumps and makes a clunk sound

Hi Zach. Thanks for contacting us today. There are a few things you should look into with these symptoms. First and most common is that the clunk sound you hear is coming from a loose driveshaft. This could be due...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com