Mercedes-Benz 300SE Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(12)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(12)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz 300SE Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1964 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
1990 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1966 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1963 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
1960 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
1965 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1993 Mercedes-Benz 300SEL6-3.2LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$117.28 - $130.25
1961 Mercedes-Benz 300SEL6-3.0LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$117.94 - $131.39
Show example Mercedes-Benz 300SE Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(12)

Rating Summary
10
1
0
0
1
10
1
0
0
1

Nick

14 years of experience
90 reviews
Nick
14 years of experience
Mercedes-Benz 300SE L6-3.0L - Window Regulator Replacement (Driver Side Front) - Sacramento, California
excellent service..conciencence service.and cleanup.

Matthew

33 years of experience
1240 reviews
Matthew
33 years of experience
Mercedes-Benz 300SE L6-3.0L - Fuel Pump - Norfolk, Virginia
Excellent.

Joe

23 years of experience
85 reviews
Joe
23 years of experience
Mercedes-Benz 300SE L6-3.0L - Alternator - Mansfield, Texas
Excellent work and very personable.

Nickolas

6 years of experience
54 reviews
Nickolas
6 years of experience
Mercedes-Benz 300SE L6-3.2L - Oil Change - Olathe, Kansas
Was interesting and great work!

Excellent Rating

(12)

Rating Summary
10
1
0
0
1
10
1
0
0
1
Number of Mercedes-Benz 300SE services completed
132+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

P0040 OBD-II Trouble Code: O2 Sensor Signals Swapped Sensor 1
P0040 P0040 code definition P0040 indicates that there is an issue with the oxygen sensor sensor 1 circuit. This code can be in conjunction with P0041 What the P0040 code means P0040 is a specific code indicating a problem with...
10 Best Stores to Buy Auto Parts in New Orleans, Louisiana
Automotive technicians rely on auto parts stores to add and replace car parts. The best auto parts shop in New Orleans is AutoZone.
How to Repair a Door Lock Actuator
The power door lock actuator can be integral to a car door lock repair. If a remote device or unlock switch fails, the actuator may be faulty.

Engine block cracked

Your engine has a cast iron block and aluminum heads. There are ways of repairing cast iron blocks: pinning, flame-spray welding and furnace welding. However, these processes have their limitations and are time consuming. Plus, most repair shops aren't willing...

AC taking too long to cool. 2010 Honda Crosstour

Hello. It is possible that the air conditioning system needs a recharge (https://www.yourmechanic.com/services/ac-recharge). There could also be a problem with the air conditioning compressor (https://www.yourmechanic.com/services/ac-compressor-replacement) in that it needs to be replaced or that it is clogged. If you'd like...

Passenger rear wheel is scraping on suspension

I would first recommend getting an alignment check to determine what the angles look like. Based on this, bent suspension parts should be more easily identified. If the vehicle cannot be aligned in its current condition, camber bolt kits are...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com