Ford Windstar Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(176)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(176)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Ford Windstar Water Pump Replacement is $472 with $136 for parts and $336 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1999 Ford WindstarV6-3.0LService typeWater Pump ReplacementEstimate$644.44Shop/Dealer Price$721.19 - $932.00
1996 Ford WindstarV6-3.0LService typeWater Pump ReplacementEstimate$622.82Shop/Dealer Price$695.33 - $902.96
1997 Ford WindstarV6-3.0LService typeWater Pump ReplacementEstimate$622.82Shop/Dealer Price$695.39 - $903.06
2001 Ford WindstarV6-3.8LService typeWater Pump ReplacementEstimate$967.56Shop/Dealer Price$1070.89 - $1364.16
1997 Ford WindstarV6-3.8LService typeWater Pump ReplacementEstimate$967.56Shop/Dealer Price$1076.78 - $1374.48
1995 Ford WindstarV6-3.0LService typeWater Pump ReplacementEstimate$622.82Shop/Dealer Price$695.72 - $903.65
1996 Ford WindstarV6-3.8LService typeWater Pump ReplacementEstimate$967.56Shop/Dealer Price$1070.95 - $1364.28
2000 Ford WindstarV6-3.8LService typeWater Pump ReplacementEstimate$967.56Shop/Dealer Price$1070.89 - $1364.16
Show example Ford Windstar Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Ford mechanics

Real customer reviews from Ford owners like you.

Excellent Rating

(176)

Rating Summary
163
9
1
1
2
163
9
1
1
2

Jonathan

25 years of experience
42 reviews
Jonathan
25 years of experience
Windstar 2000 - Ignition Coil - Marietta, GA
Explains everything until you understand. Friendly Listens to the customer's concerns and if there is an issue is ready to fix any issues

William

30 years of experience
377 reviews
William
30 years of experience
Windstar 1996 - Car is slow to accelerate - Tolleson, AZ
Thank you

Arturo

25 years of experience
253 reviews
Arturo
25 years of experience
Windstar 2001 - Vacuum Booster - San Diego, CA
He showed up early, super nice and very quick!

Raymond

25 years of experience
137 reviews
Raymond
25 years of experience
Windstar 2001 - Brake Wheel Cylinder - Hesperia, CA
Great job! Thanks so much for getting me back on the road.

Excellent Rating

(176)

Rating Summary
163
9
1
1
2
163
9
1
1
2
Number of Ford Windstar services completed
1936+
services done by our mechanics
TOTAL NUMBER OF EXPERT Ford MECHANICS
1800+
experts on our platform

Recent articles & questions

P2121 OBD-II Trouble Code: Throttle/Pedal Position Sensor/Switch D Circuit Range/Performance
P2121 means there is a problem with a particular throttle position sensor circuit
How to Diagnose Problems With Your Suspension System
Many car owners become aware that it is time to investigate their vehicle's suspension components when their car starts to...
How to Quickly and Accurately Find the Source of an Oil Leak
When it comes down to car fluid leaks, oil leaks are among the most common. Degreaser and U/V leak detector kits can help you find the source.

Thumping noise and vibration at lower speeds

Hello there, with the 2002 CL500 and many other older vehicles it is not uncommon to develop vibration issues. The most common causes would be a damaged rim, out-of-balance tire, failed strut (https://www.yourmechanic.com/services/strut-assembly-replacement) or shock (https://www.yourmechanic.com/services/shock-absorber-replacement), or another failed suspension...

Burning or hot smell coming from under the back of car 2009 Dodge Journey

Hi there - there could be several causes for "something's hot (https://www.yourmechanic.com/question/burning-smell-from-car)": a clogged catalytic converter, dragging brake, blocked muffler, and so on. This task might require a remote infrared heat sensor (so you don't have to crawl under the...

Loose rattling noise from passenger front wheel?

The tie rod is supposed to move like that. If you only get noise on bumps then it is most likely cause by the struts and top strut mounts are loose and worn out.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com