Ford F-250 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(122)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(122)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Ford F-250 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1976 Ford F-250V8-6.4LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1994 Ford F-250V8-5.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1970 Ford F-250L6-3.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1976 Ford F-250L6-4.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1990 Ford F-250V8-5.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1977 Ford F-250L6-4.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1987 Ford F-250V8-6.9L DieselService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1972 Ford F-250V8-5.9LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Ford F-250 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Ford mechanics

Real customer reviews from Ford owners like you.

Excellent Rating

(122)

Rating Summary
113
4
0
1
4
113
4
0
1
4

Larry

16 years of experience
116 reviews
Larry
16 years of experience
Ford F-250 V8-4.6L - Car starts and then dies - Columbus, Ohio
Was on time and professional would use again.

Sean

17 years of experience
111 reviews
Sean
17 years of experience
Ford F-250 V8-5.8L - Car starts and then dies - Alexandria, Virginia
Very knowledgable. Quickly diagnosed vehicle issue. Very professional.

Carlos

16 years of experience
362 reviews
Carlos
16 years of experience
Ford F-250 V8-7.5L - When I slow down and stop the car, engine shuts off - Fort Worth, Texas
Friendly guy. Very professional.

Robert

42 years of experience
232 reviews
Robert
42 years of experience
Ford F-250 * - Car is not starting - Tomball, Texas

Excellent Rating

(122)

Rating Summary
113
4
0
1
4
113
4
0
1
4
Number of Ford F-250 services completed
1342+
services done by our mechanics
TOTAL NUMBER OF EXPERT Ford MECHANICS
1700+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Lexus LS 600h L
The The “h” stands for hybrid, and while you might hope to get greatly improved gas mileage for your effort to go green, that shouldn’t be your motivation for buying this model. The 600h L offers a mere 1 mpg...
How to Transfer a Car Title in Vermont
In In the state of Vermont, all changes in vehicle ownership must be accompanied by a change in the name on the title. The title transfer process is relatively simple and straightforward, but there are several steps that must be...
10 Best Stores to Buy Auto Parts in San Diego, California
Automotive technicians rely on auto parts stores to add and replace car parts. The best auto parts shop in San Diego is O’Reilly Auto Parts.

Service Traction ESC light came on, What is this?

The ESC light indicates that there is a problem with the Electronic Stability Control. Many times this is caused by a failing wheel speed sensor (https://www.yourmechanic.com/services/wheel-speed-sensor-replacement). Have the vehicle scanned (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) and diagnostic trouble codes read to help indicate if...

While highway driving, rear tire blew out

The rubber tires on any vehicle can experience a blowout under a number of conditions. If the tire is low on air pressure, the added grip causes more friction, heat, and wear. If a tire has an unseen injury, a...

Check engine light came on and got a code p0015. I didn't notice anything while driving.

Hi there. When getting the code P0015 (https://www.yourmechanic.com/article/p0015-obd-ii-trouble-code-camshaft-position-b-timing-over-retarded-bank-1-by-jay-safford), the main thing to check is to verify the operation of the Variable Camshaft Timing (VCT) solenoid. This solenoid is operated by the oil pressure in the engine. If the oil in...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com