Ford F-150 Lightning Lubricate Driveshaft at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(19,632)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(19,632)

Lubricate Driveshaft Service

How much does a Lubricate Driveshaft cost?

On average, the cost for a Ford F-150 Lightning Lubricate Driveshaft is $105 with $0 for parts and $105 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2022 Ford F-150 LightningElectricService typeLubricate DriveshaftEstimate$124.99Shop/Dealer Price$133.39 - $139.69
Show example Ford F-150 Lightning Lubricate Driveshaft prices

What is lubricating the driveshaft all about?

Along the drivetrain, whenever torque needs to travel from one place to another, a driveshaft is used. Some cars have two driveshafts under them, usually for four-wheel-drive applications. U-Joints are couplings that hold sections of driveshaft together and can withstand large amounts of torque. The U-joint and the slip both need lubrication to work smoothly. This means lubricant needs to be applied to every point where the driveshaft meets another section of shaft or any other part of the vehicle.

Keep in mind:

  • While lubricating will help with scraping noise and minor vibration, it will not repair actually broken parts.
  • Inspect the parts of the the driveshaft to make sure they do not need full replacement.
  • Even small spots of excess wear are bad on parts that withstand so much torque, no problem is too small to be addressed on the driveshaft.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The slip joints and U-joints on all drive shafts are located
  • The Zerk grease fittings on the slip joint and U-joints are located
  • New grease is pumped into the grease fittings with a grease gun
  • The vehicle is lowered off of the jack stands

Our recommendation:

Check the manual of your vehicle to see if the manufacturer has specific instructions on servicing and lubricating the driveshaft. If the manufacturer suggests it is time for a service or if the vehicle has symptoms of a malfunctioning driveshaft, then it should be done immediately. These parts are under a lot of force and will usually fail when the car is in motion. While under the vehicle, inspect all of the connections along the drivetrain and keep an eye out for any parts that seems excessively worn. Bring a rag and wipe any mud or dust off to check for damage.

What are the common symptoms indicating you need to lubricate the driveshaft?

  • Clicking or grating sounds while the vehicle is in gear
  • Vibration in the vehicle while it is running

How important is this service?

This service is very important. Poor lubrication is one of the top reasons why driveshafts fail. When they do fail, driveshafts will fail while in motion and can take out more expensive parts around them. These preventative maintenance steps are extremely important in order to avoid more costs down the road.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Ford mechanics

Real customer reviews from Ford owners like you.

Excellent Rating

(19,632)

Rating Summary
18,424
649
126
104
329
18,424
649
126
104
329

Carlton

39 years of experience
14 reviews
Carlton
39 years of experience
Ford F-150 V8-5.0L - Lubricate Driveshaft - Woodbridge, Virginia
He was not able to perform the service because my drive shaft is sealed. He took a look at it and said it was good, however after I started driving again, the clunk and noise is still there. I am not satisfied with the service provided by your website. I paid $80 for a person to come over and do and inspection on my car. Had I taken the truck to his shop he would have not charged me after looking at it for 2 minutes like he did at my home. I think it’s fair to pay the gentleman for his time and drive ($40), however I don’t think it’s for for me to pay you the remainder. If you are going to offer these types of services, the. Your website should be savvy enough to be able to tell me that this job was not one he could have done at my home and saved me the money. I feel like I should get a partial refund since the job was not done. I should note that Carlton “Wayne” was great.

Mahdi

10 years of experience
94 reviews
Mahdi
10 years of experience
Ford F-150 V6-4.2L - Car is not starting - Buford, Georgia
Mahdi was very friendly and helped me figure out the problem with my truck. He recommended some needed services and will be calling on him again. thanks again

Faraz

22 years of experience
84 reviews
Faraz
22 years of experience
Ford Excursion V10-6.8L - Brakes, Steering and Suspension Inspection - Newark, California
Very good.

Brian

18 years of experience
74 reviews
Brian
18 years of experience
Ford F-250 Super Duty V8-5.4L - Pre-purchase Car Inspection - Lodi, California
Brian was great! Awesome sense of humor and very thorough and professional. He walked me through the many things wrong with the truck I wanted to buy, and even ended up negotiating for me and saving me $500 off what I had asked for! Thanks again Brian, you're the man!

Excellent Rating

(19,632)

Rating Summary
18,424
649
126
104
329
18,424
649
126
104
329
Number of Ford services completed
215952+
services done by our mechanics
TOTAL NUMBER OF EXPERT Ford MECHANICS
1700+
experts on our platform

Recent articles & questions

How Long Does a Timing Cover Last?
A A timing cover protects parts such as the timing belt, timing chain, and gears inside of your vehicle. They are made from either plastic, metal, or a combination of synthetic materials. In modern vehicles, the covers are designed to...
P0115 OBD-II Trouble Code: ECT Sensor Circuit Malfunction Problem
P0115 P0115 code definition Engine Coolant Temperature (ECT) sensor circuit malfunction problem What the P0115 code means P0115 is the OBD-II generic code that indicates when the engine control module (ECM) reads the ECT sensor input go below or above...
How to Prepare for the Utah Driver’s Written Test
It It is not possible to get a learner’s permit in Utah until you have first taken and passed your driver’s written test. Driving is an important responsibility, and you need to prove to the state that you have the...

What Does a Starter Motor Do?

The starter motor (https://www.yourmechanic.com/article/how-does-a-starter-motor-work) is a 12 volt, permanent magnet DC motor that engages a small drive gear on the starter with a larger ring gear that is attached to the flexplate, or flywheel. The flexplate is bolted to the...

Problems shifting gears

It sounds like your 2002 Honda Passport may have an issue with its gear selection sensor (https://www.yourmechanic.com/services/transmission-position-sensor-switch-replacement). This sensor provides information to the powertrain control module as to which gear the vehicle is in. If this sensor is giving false...

What is a chevy hhr Lt 2006 2.2 or 2.4

The transmission used in the 2.2 L version of your car is not interchangeable with a transmission from the 2.4 L version. To determine whether you have a 2.2 L engine or a 2.4 L engine, please look at the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com