Chevrolet S10 Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Chevrolet S10 Car Battery Replacement is $285 with $145 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1992 Chevrolet S10L4-2.5L	Service typeCar Battery Replacement	Estimate$522.16	Shop/Dealer Price$617.55 - $895.62
1995 Chevrolet S10V6-4.3L	Service typeCar Battery Replacement	Estimate$436.55	Shop/Dealer Price$511.02 - $730.32
1992 Chevrolet S10V6-4.3L	Service typeCar Battery Replacement	Estimate$513.15	Shop/Dealer Price$606.80 - $883.56
2001 Chevrolet S10L4-2.2L	Service typeCar Battery Replacement	Estimate$436.55	Shop/Dealer Price$511.05 - $730.36
1997 Chevrolet S10L4-2.2L	Service typeCar Battery Replacement	Estimate$436.55	Shop/Dealer Price$512.52 - $732.94
1998 Chevrolet S10L4-2.2L	Service typeCar Battery Replacement	Estimate$436.55	Shop/Dealer Price$511.19 - $730.61
1999 Chevrolet S10V6-4.3L	Service typeCar Battery Replacement	Estimate$436.55	Shop/Dealer Price$511.06 - $730.39
1994 Chevrolet S10L4-2.2L	Service typeCar Battery Replacement	Estimate$436.55	Shop/Dealer Price$511.05 - $730.36

Show example Chevrolet S10 Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(6)

Rating Summary

5

1

0

0

0

5

1

0

0

0

SEE REVIEWS NEAR ME

Walter

43 years of experience

238 reviews

Walter

43 years of experience

by John L Mc Partland

S10 2002 - Battery - Broken Arrow, OK

Walter was great, and gave me some good tips on keeping it running. Would definitely recommend Walter(and your company) in the future. Walter also wore his mask the entire visit which was important to us and one of the reasons we chose you guys.

Christopher

20 years of experience

1 reviews

Request Christopher

Christopher

20 years of experience

Request Christopher

by Allan Williams

S10 2001 - Starter - Holiday, FL

Chris did a great job for me. He showed up on time and completed the task in the time frame he said he would..Very polite and professional.

Nolan

0 years of experience

120 reviews

Nolan

0 years of experience

by Susan Mckenzie

S10 1996 - Oil/Fluid Leak - Tucson, AZ

He seems like a trust whearthy macanic .I would put my trut into .for doing the work on my truck

Alex

18 years of experience

72 reviews

Alex

18 years of experience

by Herbert Agustin

S10 1989 - Car is not starting - Yorkville, IL

I learn a lot on Alex specially on this kind of old truck

Excellent Rating

(6)

Rating Summary

5

1

0

0

0

5

1

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

B1942 OBD-II Trouble Code: Airbag Crash Sensor #2 Feed/Return Circuit Open

B1942 means there is a fault in the voltages to two terminals in the airbag circuit, likely due to a bad sensor or open circuit issue.

A Buyer’s Guide to the 2012 Volkswagen Touareg TDI

The The 2012 Volkswagen Touareg TDI brings diesel to the family in a big way. This crossover SUV delivers seamless performance in a vehicle that obviously designed for the open road rather than any trails or other types of off-road...

How to Renew Your Car Registration in New Jersey

Living Living in New Jersey comes with a variety of advantages. The great roadways and bridges that are a part of this state’s landscape are funded by the hard working men and women who live there. One of the main...

Windshield wipers not working.

This seems like the switch (https://www.yourmechanic.com/services/windshield-wiper-switch-replacement) is on its way out, I would have a certified mechanic verify that 12 volts is being applied to the windshield wiper motor. If power is present and the wiper isn't working its the...

Gas Pedal is very hard at beginning and RPMs drop.

If the throttle assembly has a cable that attaches the pedal to the throttle valve, the cable must be inspected to see if it is binding within the insulation. Excessive carbon build-up may cause the throttle plate to stick (https://www.yourmechanic.com/services/clean-throttle-body),...

Service Engine light code P0011

Hello. I will help you with this issue. There are more than 5,000 Diagnostic Trouble Codes (DTC's) that a modern OBD-II vehicle such as yours could report. Any and all initial diagnostic work following up ANY of those codes is...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com