Chevrolet S10 Blazer Front Crankshaft Seal Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(20)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(20)

Front Crankshaft Seal Replacement Service

How much does a Front Crankshaft Seal Replacement cost?

On average, the cost for a Chevrolet S10 Blazer Front Crankshaft Seal Replacement is $159 with $19 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1991 Chevrolet S10 BlazerV6-4.3LService typeFront Crankshaft Seal ReplacementEstimate$244.70Shop/Dealer Price$260.18 - $296.09
1993 Chevrolet S10 BlazerV6-4.3LService typeFront Crankshaft Seal ReplacementEstimate$189.19Shop/Dealer Price$201.82 - $235.60
1992 Chevrolet S10 BlazerV6-4.3LService typeFront Crankshaft Seal ReplacementEstimate$232.99Shop/Dealer Price$246.20 - $280.42
1990 Chevrolet S10 BlazerV6-4.3LService typeFront Crankshaft Seal ReplacementEstimate$232.99Shop/Dealer Price$246.20 - $280.41
1994 Chevrolet S10 BlazerV6-4.3LService typeFront Crankshaft Seal ReplacementEstimate$232.99Shop/Dealer Price$248.12 - $283.77
Show example Chevrolet S10 Blazer Front Crankshaft Seal Replacement prices

What is the Front Crankshaft Seal all about?

A number of mechanisms must work together to make your vehicle move forward. One of the most important is the crankshaft, which converts rotary into linear motion; i.e., it transforms the force created by the engine's pistons moving up and down into a force that moves in a circular motion that causes a car’s wheel to turn. Enclosed in what’s called a crankcase—the largest cavity in the engine block, just below the cylinders—the crankshaft must be completely lubricated, essentially submerged in oil, to spin nearly friction-free and do its job properly.

Consequently, there are seals located at either end of the crankshaft that allow it to spin freely and keep engine oil from escaping the engine block, as well as prevent contaminants and other debris from entering and causing damage to the mechanism. Since there are two ends of the crankshaft, there are two types of seals: the front crankshaft seal and the rear crankshaft seal, also known as the front main and rear main seals.

Keep in mind:

  • Loss of oil will eventually cause serious internal engine damage.
  • Inspect the sealing surface of the crankshaft or the crankshaft pulley (depending on the engine design) for damage when replacing the crankshaft seal.
  • Oil degrades rubber components.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The crankshaft damper and timing belt is removed
  • The crankshaft seal is removed and a new one installed
  • The timing belt and cover along with crankshaft damper is reinstalled
  • The engine accessory belts are installed and the vehicle is lowered off of the jack stands

Our recommendation:

One of the most important parts of your car, crankshaft seals are typically made from a durable material, such as a synthetic rubber or silicone, designed to handle the extreme pressure and temperatures as well as the caustic chemicals in your engine oil. Because they are exposed to such abuse, main seals are subject to a lot of wear and tear. And whether you are talking a front or rear main seal, replacement is the only cure when one malfunctions.

The good news is that the seals are relatively inexpensive components. The bad news is that neither is easy to replace.

Front seal: The front seal is located behind the main pulley that drives all the belts, which is, of course, always spinning. The main pulley throws any leaking oil out in a big circle. It can get thrown up on the alternator, steering pump, belts, in short anything attached to the front of the engine and cause a real mess and eventually some serious damage. Consequently, it has to be removed along with many of the components attached to the front of the block to replace the front main seal.

Rear seal: The rear crankshaft seal is placed along with the transmission; therefore, the process of replacing it requires the removal of transmission, as well as the clutch and flywheel assembly. This is a very involved job.

What common symptoms indicate you may need to replace the Front Crankshaft Seal?

  • Oil leaking from the front crank pulley.
  • Oil dripping from the bottom of the clutch housing, where the block and transmission meet.
  • Clutch slip caused by oil spraying on the clutch.

How important is this service?

Letting either crankshaft seal continue to leak can be detrimental to your vehicle’s continued operation. Besides the maladies caused by driving around with little to no oil flowing in the engine, the faulty seal will be spread oil through the engine bay and undercarriage of your car as you drive, a mess that is difficult to clean up and can be a fire hazard. Replacing is better addressed sooner than later.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(20)

Rating Summary
15
2
1
0
2
15
2
1
0
2

John

33 years of experience
1126 reviews
John
33 years of experience
Chevrolet S10 Blazer V6-4.3L - Car is not starting - Houston, Texas
I was unsure I actually needed the repair I requested. John helped get to the actual issue without hesitation, changing service request to my vehicles needs.

Edgar

26 years of experience
41 reviews
Edgar
26 years of experience
Chevrolet S10 Blazer V6-4.3L - Check Engine Light is on - Redwood City, California

Albert

23 years of experience
81 reviews
Albert
23 years of experience
Chevrolet S10 Blazer V6-2.8L - Car is not starting - Loganville, Georgia
Great work! Albert explained work as he went along and was very knowledgeable

Wesley

14 years of experience
53 reviews
Wesley
14 years of experience
Chevrolet S10 Blazer V6-2.8L - Car is not starting - San Antonio, Texas
Bought my vehicle a month ago with a few problems, it is a little older so I expected it. Spent a month and about 150 dollars do small things trying to figure out the problems, after my own research I was about to spend close to 600 dollars on a myriad of parts to replace the would fix almost any issue. Wesley comes out takes 15 minutes and notices a loose wire on my starter that was causing all my problems. Needless to say I felt ridiculous, but I am glad I didn't spend that much money on parts that would have not fixed the problem. He also recommended a couple of tune up measures I could take to make the engine purr. He was a pleasure to talk to and have working on my vehicle.

Excellent Rating

(20)

Rating Summary
15
2
1
0
2
15
2
1
0
2
Number of Chevrolet S10 Blazer services completed
220+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1700+
experts on our platform

Recent articles & questions

How to Replace a Crankshaft Position Sensor
The crankshaft position sensor, along with the camshaft sensor, helps the vehicle determine top dead center, among other engine management tasks.
How to Drive in Fog Safely
Driving Driving in fog is one of the most dangerous situations in which drivers can find themselves, because fog greatly interferes with visibility. When possible, drivers should opt against driving in such conditions and wait for the fog to lift....
How to Unlock a Chevrolet Theftlock Radio
Theftlock Theftlock is a theft prevention system designed into GM-brand radios starting in the mid-1990’s. This system is designed to lock the radio from use in the event of a loss of power, either from being disconnected or when the...

Heater

The heater uses hot engine coolant to warm the vehicle cabin. If the heater is blowing cold, the first thing to check is the coolant level. Low coolant, or a problem somewhere in the cooling system, will affect heater operation....

My dad added a quart of regular oil to my car which uses synthetic. He drove it 800 miles before I knew. It hasn't had any probl

You should not worry about the addition of normal oil instead of synthetic oil. The oil should be changed at the normal time. The oil system does not need to be flushed. Any time the oil is low you should...

My car cuts off once it gets hot and there's white smoke

It is very possible that you could have an oil leak from your valve cover gasket. If this happens this oil can land on the exhaust and burn away causing the white smoke you are seeing. I would recommend having...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com