Buick Riviera Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(33)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(33)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Buick Riviera Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1980 Buick RivieraV8-5.7L DieselService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1989 Buick RivieraV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1993 Buick RivieraV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1984 Buick RivieraV6-3.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1974 Buick RivieraV8-7.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1995 Buick RivieraV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1980 Buick RivieraV8-5.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1988 Buick RivieraV6-3.8LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Buick Riviera Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Buick mechanics

Real customer reviews from Buick owners like you.

Excellent Rating

(33)

Rating Summary
29
2
0
2
0
29
2
0
2
0

Raul

34 years of experience
285 reviews
Raul
34 years of experience
Buick Riviera V6-3.8L - Car is not getting enough power - Hayward, California
Paul has an impressive understanding of how engines function. He is an excellent diagnostician. He is always upbeat and positive. I highly recommend him.

Jerome

24 years of experience
415 reviews
Jerome
24 years of experience
Buick Riviera V6-3.8L Turbo - Brake Rotor/Disc Replacement (Front) - Rosedale, Maryland
Jerome sold me on the whole idea of the come to you mechanic, you need to keep him around. Thanks Jerome

Ejnar

29 years of experience
107 reviews
Ejnar
29 years of experience
Buick Riviera V8-6.6L - Car is not starting - Milpitas, California
Quickly found the problem and the solution.

Jeff

17 years of experience
1 reviews
Jeff
17 years of experience
Buick Riviera V6-3.8L - Window is not working - Castro Valley, California
Very informative. On time. Easy to work with.

Excellent Rating

(33)

Rating Summary
29
2
0
2
0
29
2
0
2
0
Number of Buick Riviera services completed
363+
services done by our mechanics
TOTAL NUMBER OF EXPERT Buick MECHANICS
800+
experts on our platform

Recent articles & questions

Does An Automatic Transmission Have a Clutch?
Most of the time we think of a clutch in the context of a manual transmission. An automatic transmission does have...
P0271 OBD-II Trouble Code: Cylinder 4 Injector Circuit High
P0271 P0271 code definition Cylinder 4 Injector Circuit High What the P0271 code means This diagnostic trouble code (DTC) (https://www.yourmechanic.com/article/what-is-the-on-board-diagnostics-obd-system) indicates that a reference voltage from the fuel injector associated with cylinder number 4 has gone higher than the range...
Is Pay-Per-Mile Insurance Right for You?
Chances Chances are you pay the same amount for your car insurance bill each month, unless you make a change to your policy or vehicle. But if you go days (or weeks) without driving, doesn’t it seem unfair that your...

Code p0421

Are there other codes set? This code, by itself, P0421 (https://www.yourmechanic.com/article/p0421-obd-ii-trouble-code-warm-up-catalyst-efficiency-below-threshold-bank-1-by-andrew-quinn) indicates that the engine management system detected the catalytic converter is performing below expected standards. This means the engine is sending contaminants (unburned fuel, oil fumes, etc.) down the...

Check vsc system

Hi There, The VSC light relates to the Vehicle Stability Control system which is your car's traction control system. The traction control system monitors the steering stability of the vehicle and engages when loss of traction has been detected. This...

I was just told that a tensioner or pulley could have caused my alternator to go bad and if not replaced could make the new one go

Pulleys do go bad because the grease in the pulley bearing dries out, the ball bearings and bearing races get pitted and then the pulley becomes noisy. Sometimes, the pulley will actually seize. However, it will be EASILY evident if...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com