Buick Enclave Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(220)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(220)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Buick Enclave Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2014 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2020 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2018 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2010 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2017 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2012 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2021 Buick EnclaveV6-3.6LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Buick Enclave Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Buick mechanics

Real customer reviews from Buick owners like you.

Excellent Rating

(220)

Rating Summary
210
5
1
1
3
210
5
1
1
3

Torrieanto

12 years of experience
632 reviews
Torrieanto
12 years of experience
Buick Enclave V6-3.6L - Reduced Power light is on - Riverview, Florida
He was very polite and he explained to me so I could understand why I was having the problem I was having.

Matthew

33 years of experience
1222 reviews
Matthew
33 years of experience
Buick Enclave V6-3.6L - Oil/Fluid Leak - Hampton, Virginia
Very knowledgeable and willingness to help. Went above and beyond. I highly recommend him!

Brett

10 years of experience
197 reviews
Brett
10 years of experience
Buick Enclave V6-3.6L - Brakes, Steering and Suspension Inspection - Austin, Texas
Always on time and gets right down to business. Brett really seems to know his stuff.

Travis

13 years of experience
160 reviews
Travis
13 years of experience
Buick Enclave V6-3.6L - Oil Change - Charlotte, North Carolina
Travis was 15 minutes early. Got right to work and did a great job on my Enclave! He is friendly, professional, knowledgeable and highly skilled! I only request him now for my wife's and my vehicles!

Excellent Rating

(220)

Rating Summary
210
5
1
1
3
210
5
1
1
3
Number of Buick Enclave services completed
2420+
services done by our mechanics
TOTAL NUMBER OF EXPERT Buick MECHANICS
800+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Brake Caliper
Common signs include brake fluid leaks, abnormal sounds, and vehicle pulling to the left or right.
Symptoms of a Bad or Failing Steering Column Actuator
Common signs include difficulty starting the car, being able to take the key out of the ignition anytime, and an overheating ignition switch.
P0303 OBD-II Trouble Code: Cylinder 3 Misfire Detected
P0303 code definition P0303 is a generic diagnostic trouble code (DTC) indicating an issue with the firing of cylinder 3. This code...

Leaking rubber fuel line

That is most likely the injection pump feed line that is leaking. This line, if leaking, will need to be replaced (https://www.yourmechanic.com/services/fuel-injection-lines-replacement). The key must be off and out of the ignition to prevent accidental startup of the fuel feed...

How do I rewire under the dash pad? Many of the wires are just there disconnected and some are damaged.

Hello. If you were to purchase an entirely new harness that is made for your vehicle, it should a simple plug and play. I would not recommend tearing everything out. But instead, if I were to do it I would...

Check Engine light on. Would the computer give all error codes in one shot? How do we know the engine's condition?

Hi there. From the description you have provided, I'm am inclined to agree with your assessment of a used engine being installed in your vehicle. An inspection of the engine, by a qualified technician could determine whether the engine is...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com