BMW 335is Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(4)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(4)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a BMW 335is Water Pump Replacement is $1108 with $688 for parts and $420 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2012 BMW 335isL6-3.0L TurboService typeWater Pump ReplacementEstimate$1840.94Shop/Dealer Price$2203.83 - $3249.96
2013 BMW 335isL6-3.0L TurboService typeWater Pump ReplacementEstimate$1813.91Shop/Dealer Price$2167.52 - $3206.70
2011 BMW 335isL6-3.0L TurboService typeWater Pump ReplacementEstimate$1813.91Shop/Dealer Price$2167.66 - $3206.93
Show example BMW 335is Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0

Ben

30 years of experience
59 reviews
Ben
30 years of experience
BMW 335is L6-3.0L Turbo - Serpentine/Drive Belt - Acworth, Georgia
Ben did a great job!! I would use him again.

Shaun

11 years of experience
542 reviews
Shaun
11 years of experience
BMW 335is L6-3.0L Turbo - Battery - Scottsdale, Arizona
Shaun did a great job.

John

33 years of experience
1126 reviews
John
33 years of experience
BMW 335is L6-3.0L Turbo - Oil Change - Houston, Texas
On time and very efficient!

Alex

24 years of experience
464 reviews
Alex
24 years of experience
BMW 335is L6-3.0L Turbo - Brake Pads Replacement (Rear) - Addison, Texas
Alex is my new go-to mechanic. He was very informative and answered all my questions. I won't use anyone else.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0
Number of BMW 335is services completed
44+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1200+
experts on our platform

Recent articles & questions

Disabled Driver Laws and Permits in Rhode Island
In In Rhode Island, there are laws in place that allow special privileges to handicapped drivers. If you are handicapped, then you will be entitled to special placards or license plates that identify you as such, and you will be...
P2227 OBD-II Trouble Code: Barometric Pressure Circuit Range/Performance
P2227 trouble code definition Either the barometric pressure sensor is providing a reading that does not correspond to the parameters of the...
How Long Does a Trunk Light Bulb Last?
With With all of the parts of a car, it can be a bit overwhelming when trying to keep up with everything. The lights that are on a car serve a variety of different purposes and keeping them working should...

Key stuck in ignition of a 1988 Chevrolet Camaro

If this is an automatic you can try wiggling the shifter while trying to turn the keys, there is a rod that actuates a lock in the lock cylinder unless its in park. If that doesn't help the lock is...

What oil should I use in my 04 Audi A4 3.0L V6 Quattro S Line, either 5W30 or 0W40-10W40?

Viscosities of 5W-40, 5W-30, 0W-40, and 0W-30 are all specified for your model, the main selection criteria being the ambient temperature you are operating in. If you are in Alaska, use 0W-30. If you are in the southeastern desert, use...

The crankshaft damper pulley is not aligned with the pulleys of the alternator, steering pump, air-conditioner and idler. Subaru Outback 2001, 2.5 liter.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com