Audi A5 Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(10)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(10)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Audi A5 Car Battery Replacement is $390 with $250 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2013 Audi A5L4-2.0L TurboService typeCar Battery ReplacementEstimate$655.36Shop/Dealer Price$786.75 - $1166.75
2012 Audi A5L4-2.0L TurboService typeCar Battery ReplacementEstimate$646.35Shop/Dealer Price$774.65 - $1152.33
2010 Audi A5L4-2.0L TurboService typeCar Battery ReplacementEstimate$646.35Shop/Dealer Price$774.69 - $1152.40
2014 Audi A5L4-2.0L TurboService typeCar Battery ReplacementEstimate$646.35Shop/Dealer Price$774.69 - $1152.40
2011 Audi A5L4-2.0L TurboService typeCar Battery ReplacementEstimate$646.35Shop/Dealer Price$777.27 - $1156.91
Show example Audi A5 Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Audi mechanics

Real customer reviews from Audi owners like you.

Excellent Rating

(10)

Rating Summary
9
0
1
0
0
9
0
1
0
0

Zackery

6 years of experience
52 reviews
Zackery
6 years of experience
Audi A5 L4-2.0L Turbo - Serpentine/Drive Belt - Everett, Washington
Dude was awesome!!

Dellano

19 years of experience
554 reviews
Dellano
19 years of experience
Audi A5 L4-2.0L Turbo - Brake Pads Replacement (Front, Rear) - Washington, District of Columbia
Great to work with Dellano again. Fast, friendly and always goes the extra mile for the customer. Highly recommended.

James

32 years of experience
705 reviews
James
32 years of experience
Audi A5 L4-2.0L Turbo - Brakes, Steering and Suspension Inspection - Fullerton, California
Excellent experience. On time. Professional. Courteous. Honest. I requested brake pad repair (only because dealer said so, and I already procrastinated a year), but James took a look and said it's still good! No need for replacement, but James still did a thorough inspection on the car. Appreciate the time he took to explain things, the audio and visual report as well.

Shaun

17 years of experience
238 reviews
Shaun
17 years of experience
Audi A5 L4-2.0L Turbo - Brake Pads Replacement (Front, Rear) - Los Gatos, California
Completed Break replacement

Excellent Rating

(10)

Rating Summary
9
0
1
0
0
9
0
1
0
0
Number of Audi A5 services completed
110+
services done by our mechanics
TOTAL NUMBER OF EXPERT Audi MECHANICS
800+
experts on our platform

Recent articles & questions

5 Essential Things to Know About Off-Roading
Ah, Ah, the thrill of going off-road! If you’ve done it, you know there’s nothing better than showing off your expertise and skill. However, if you haven’t, there are five essential things you need to know before you leave the...
B1976 OBD-II Trouble Code: Passenger’s Seat Forward Switch Circuit Short to Battery
B1976 means there is a circuit error in the passenger seat forward switch. This is likely due to damaged electrical parts or a faulty switch.
When Should I Rotate My Tires?
Refer Refer to your owner's manual for the exact tire rotation schedule for your car. The general recommendation is that tires be rotated every 5,000 to 8,000 miles, and this often coincides with oil changes. Consider exploring an in depth...

When replacing the brake switch, why would the 3rd brake light work and not all 3?

It is possible that both of the brake light bulbs (https://www.yourmechanic.com/services/brake-light-bulb-replacement) are out. It is also possible that the other two brake lights are on a separate fuse from the third brake light which could cause the third brake light...

Dark need tail lights an dash lights to work to get home.

Hi there. Hot wiring lights can be dangerous and could cause other problems. If you need the lights to work and all they are is just the dash and tail lights so you can get home, you could get a...

Is my transmission goin out or did a sensor or somrthing go out?

This is often a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com