Skip the auto shop - Our mechanics make house calls
  1. Home
  2. Articles
  3. Symptoms of a Bad or Failing Variable Valve Timing (VVT) Switch

Symptoms of a Bad or Failing Variable Valve Timing (VVT) Switch

vvt switch

The performance and fuel efficiency established by today's modern cars is possible thanks in large part to the variable valve timing system. When a car, truck or SUV is driving in normal driving conditions, the VVT is not active. However, if the vehicle is driving with extra weight in the trunk, pulling a trailer or at higher speeds, this system is activated. The specific device used to relay information from the VVT to the vehicle's computer is the variable valve timing switch.

Once activated by the variable valve timing switch, the engine of your car, truck, or SUV will receive input from the ECU to advance or retard the ignition timing. This tells the cylinder valves to open or close sooner or later than normal and also tells the ignition system to fire at a designated time in order to increase engine efficiency. The VVT solenoid operates the system while the VVT switch provides the valuable feedback to the car’s computer to adjust the timing on the fly.

Just like any other mechanical or electrical component, the VVT switch is prone to wearing out or breaking completely. In many ways, the symptoms of a failing VVT switch are similar to the symptoms of a VVT solenoid. The most common cause of failure for both the VVT switch and the VVT solenoid is a lack of basic maintenance. If your oil is dirty, sludge can clog the screen on the solenoid, causing a failure. If the engine oil level is low, you will also experience problems with VVT operation.

Here are some common symptoms that hint towards having a bad VVT switch:

1. Rough engine idle

Proper ignition timing is crucial to ensuring that your engine runs smooth and efficient. When the vehicle is under load, the VVT switch will monitor the engine and send information to the computer to adjust the valve timing as needed. However, when the switch is not working properly, its ability to send accurate data is compromised. Even though this unit is supposed to only work under non-normal driving conditions, it can cause the vehicle’s engine to run rough. If you notice that the engine has a rough idle, specifically if the engine RPM rises and falls from 100 to 300 RPM at idle, contact a local ASE certified mechanic as soon as possible.

2. Check Engine Light comes on

The Check Engine Light is activated anytime one of multiple warning codes has been produced by the vehicle’s ECU. Since the VVT switch is an electrical component, it is constantly monitored by your car’s onboard computer. When it fails or is sending inaccurate data, this will alert the car’s computer to a potential problem and light up the Check Engine Light on the dashboard. Anytime the Check Engine Light comes on, you should always contact a local mechanic to inspect the car, diagnose the problem and fix what is broken. In the case of the VVT system however, there are multiple warning codes that could indicate a specific problem, so it's best to work with a local ASE certified mechanic who has the proper diagnostic tools and access to factory codes so they can properly repair what's broken.

3. Engine stumbles when climbing hills or under load

A faulty VVT switch will also cause the engine to misfire or appear to stumble when your vehicle is loaded with extra weight, climbing hills, or when you apply quick pressure to the throttle for instant acceleration. This is caused commonly by an electrical issue with the switch and not always the switch itself. If you notice this problem and contact a local ASE certified mechanic to inspect the issue, it's highly likely that they won't have to replace the variable valve timing switch. However, proper diagnosis is needed to verify that it's a problem elsewhere. If you ignore the problem, the potential of further engine damage will increase.

Regardless of the precise cause, anytime you notice the above warning signs or symptoms, you should be proactive and contact a certified mechanic as soon as possible. If you catch a problem at the onset of the symptoms, the likelihood of fixing it without causing additional damage to other engine components increases dramatically. Contact a local expert mechanic from YourMechanic as soon as you recognize any of these symptoms.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
Still not sure about your car's issue?
Diagnose your car
What kind of issue are you experiencing?
Brakes are squeaking
Car is not starting
Car is overheating
Car is shaking (vibrating)
Fluids are leaking
Heating and A/C
Smoke or steam is coming out of the car
Warning light is on
Icon-warranty_badge-02

Skip the repair shop, our top-rated mechanics come to you.

At your home or office

Choose from 600+ repair, maintenance & diagnostic services. Our top-rated mechanics bring all parts & tools to your location.

Fair & transparent pricing

See labor & parts costs upfront, so you can book with confidence.

12-month, 12,000-mile warranty

Our services are backed by a 12-month, 12,000-mile warranty for your peace of mind.

Get A Quote

Need Help With Your Car?

Our certified mobile mechanics make house calls in over 2,000 U.S. cities. Fast, free online quotes for your car repair.

GET A QUOTE

More related articles

P0121 OBD-II Trouble Code: TPS "A" Circuit Range Performance Problem
P0121 code definition Throttle Pedal Position Sensor/Switch (TPS) A Circuit Range Performance Problem...
Veteran and Military Driver Laws and Benefits in New Mexico
The state of New Mexico offers a number of benefits and perks for those Americans who have either served in an Armed Forces branch...
P2159 OBD-II Trouble Code: Vehicle Speed Sensor B Range/Performance
Diagnostic Trouble Code (DTC): P2159 P2159 code definition Vehicle Speed Sensor B Range/Performance...


Related questions

Q: Dome lights will not turn on when door opened, radio will not turn off when car is off and door is opened.

Hello, thank you for writing in. The vehicle is likely having issues with the door switch which activates/shuts down both circuits. This is going to look like a peg in the door frame next to the hinge. The peg that...

Q: Transmission staying in 3rd gear only and not shifting.

Hi there. The transmission could have an issue with the shift solenoids. Check the wiring harness to the transmission case and make sure that it is plugged in. 3rd gear is the only forward gear in a 4L60E transmission that...

Q: Full power but no turn over when key is turned

Hey there, I believe you are correct. The most likely cause of this issue you are having would be the ignition switch. The ignition switch is responsible for sending power from the battery to the starter when you turn the...