Toyota Corolla Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(6)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(6)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Toyota Corolla Power Steering Pump Replacement is $424 with $228 for parts and $196 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$788.86Shop/Dealer Price$933.35 - $1354.67
2004 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$775.35Shop/Dealer Price$917.19 - $1336.52
2018 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$957.84Shop/Dealer Price$1141.88 - $1687.31
1993 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$762.44Shop/Dealer Price$890.70 - $1267.95
1991 Toyota CorollaL4-1.6LService typePower Steering Pump ReplacementEstimate$1051.96Shop/Dealer Price$1255.25 - $1851.64
1999 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$872.44Shop/Dealer Price$1035.36 - $1516.90
2009 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$985.85Shop/Dealer Price$1180.37 - $1757.62
2005 Toyota CorollaL4-1.8LService typePower Steering Pump ReplacementEstimate$766.35Shop/Dealer Price$905.97 - $1318.58
Show example Toyota Corolla Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(6)

Rating Summary
6
0
0
0
0
6
0
0
0
0

Gustavo

15 years of experience
303 reviews
Gustavo
15 years of experience
Corolla 1999 - Power Steering Pump - New Braunfels, TX
I am very pleased with Gustavo's promptness, politeness, knowledge and attention to detail.

Nezar

22 years of experience
15 reviews
Nezar
22 years of experience
Corolla 2006 - Battery - Fort Lauderdale, FL
Great

Nezar

22 years of experience
15 reviews
Nezar
22 years of experience
Corolla 2006 - Car is not starting - Fort Lauderdale, FL
Great

Larry

15 years of experience
23 reviews
Larry
15 years of experience
Corolla 2007 - Spark Plugs - Columbus, OH
Larry is a meticulous mechanic who takes his time to carefully diagnose and assess your vehicle. This is my 2nd time using his services and he has saved me 2200.00 after a few other mechanics who tried to dupe me. I highly recommend Larry 

Excellent Rating

(6)

Rating Summary
6
0
0
0
0
6
0
0
0
0
Number of Toyota Corolla Power Steering Pump Replacement services completed
66+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1700+
experts on our platform

Recent articles & questions

How to Troubleshoot a Slipping Clutch
There are numerous advantages to operating a vehicle with a manual transmission; many drivers claim it gives them more control over...
How Long Does a Heater Bypass Tube Last?
In In order for the cooling system on your vehicle to work, you will have to make sure that all of its components are repair free. The thermostat that is on your vehicle helps to regulate the flow of coolant...
How Long Does an Emergency Parking Brake Cable Last?
Your Your emergency parking brake is something all vehicles come with. It consists of an emergency/parking brake cable which connects the parking brake shoes to the parking brake lever. This steel cable is very thin and it runs under your...

Belt making noise.

The noise in this engine belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) is most likely the belt tensioner is weak and will make a knocking noise mostly at low engine speeds is is noticed. I would recommend having it checked and replace the tensioner and...

When shifting it bogs down then rpm shoots up and bogs down again before returning to normal.

Is the engine "new" or "re-built"? If it is a used engine, check engine compression. Loss of power on acceleration can be due to plugged fuel injectors, faulty oxygen sensors, fuel pump and/or filter, vacuum leaks including that caused by...

I have a 04 acura tsx the battery is new the alternator is new and the starter is new. How after one day of not being driven the car won't start. This is the 3rd time this is happening.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com