Nissan 240Z Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(461)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(461)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Nissan 240Z Car Battery Replacement is $255 with $160 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1972 Nissan 240ZL6-2.4LService typeCar Battery ReplacementEstimate$434.99Shop/Dealer Price$524.99 - $772.49
1971 Nissan 240ZL6-2.4LService typeCar Battery ReplacementEstimate$414.99Shop/Dealer Price$505.01 - $752.52
1973 Nissan 240ZL6-2.4LService typeCar Battery ReplacementEstimate$414.99Shop/Dealer Price$505.01 - $752.52
1970 Nissan 240ZL6-2.4LService typeCar Battery ReplacementEstimate$414.99Shop/Dealer Price$504.99 - $752.48
Show example Nissan 240Z Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Nissan mechanics

Real customer reviews from Nissan owners like you.

Excellent Rating

(461)

Rating Summary
443
12
1
0
5
443
12
1
0
5

Theodore

16 years of experience
1587 reviews
Theodore
16 years of experience
Nissan 240Z L6-2.4L - Clutch Master Cylinder - Sammamish, Washington
Great job done by Theodre working on my Classic Datsun 240Z!

Toby

10 years of experience
100 reviews
Toby
10 years of experience
Nissan Murano V6-3.5L - Battery - Keller, Texas
Toby did a very good job identifying the problem. I thought it was the starter and it was actually the battery; thus saving us money.

Manuel

32 years of experience
580 reviews
Manuel
32 years of experience
Nissan Pathfinder V6-4.0L - Battery - Newport Beach, California
Manny quickly identified the issue.

H

26 years of experience
828 reviews
H
26 years of experience
Nissan Altima L4-2.5L - Battery - Mountain View, California
Super helpful and relaxed guy. Thank you for your help!

Excellent Rating

(461)

Rating Summary
443
12
1
0
5
443
12
1
0
5
Number of Nissan Car Battery Replacement services completed
5071+
services done by our mechanics
TOTAL NUMBER OF EXPERT Nissan MECHANICS
1500+
experts on our platform

Recent articles & questions

How to Buy a Personalized License Plate in Washington
If If you are looking for a way to add some customization to your vehicle, a personalized license plate (https://www.yourmechanic.com/article/how-to-find-out-which-license-plates-are-available-in-your-state-by-brady-klopfer) may be worth considering. Personalized license plates allow you to choose a plate design that is more interesting and meaningful...
P0789 OBD-II Trouble Code: Shift/Timing Solenoid Intermittent
P0789 code means there is an issue with the gear ratio within the vehicle often due too a faulty shift solenoid or transmission blockages.
What Does the Hybrid Drive System Malfunction Warning Light Mean?
The hybrid drive system malfunction light turns on when an issue is detected with the system. It could be due to problem with the battery or a fuse.

Truck won't start after replacing head gasket

Hi, the way to tell if it was assembled incorrectly is to do a compression test on the engine and see if you have compression on all cylinders. You may have timed the engine incorrectly and this would show up...

My service air bag system light is on is this dangerous

Hello, thank you for writing in. The airbag light can illuminate for several reasons. Some of them are more serious than others, but it still is not something to take too lightly. Chrysler is infamous for electrical issues, and that...

Went to change ignition cool and spark plug....:old spark plug is completely missing. Could it have fallen into the cylinder?

If the spark plug has broken and ceramic part of plug fell inside cylinder then you will need to try and remove pieces with a camera and grab fingers or the head will need to be removed. If plug fell...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com