Mercury Mountaineer Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Mercury Mountaineer Power Steering Pump Replacement is $235 with $112 for parts and $123 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2007 Mercury MountaineerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$503.93	Shop/Dealer Price$603.66 - $871.37
2002 Mercury MountaineerV8-4.6L	Service typePower Steering Pump Replacement	Estimate$410.82	Shop/Dealer Price$488.82 - $682.22
1997 Mercury MountaineerV8-5.0L	Service typePower Steering Pump Replacement	Estimate$363.33	Shop/Dealer Price$436.31 - $625.96
2004 Mercury MountaineerV8-4.6L	Service typePower Steering Pump Replacement	Estimate$394.82	Shop/Dealer Price$468.77 - $650.15
1999 Mercury MountaineerV8-5.0L	Service typePower Steering Pump Replacement	Estimate$363.33	Shop/Dealer Price$436.33 - $625.99
2000 Mercury MountaineerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$376.63	Shop/Dealer Price$450.19 - $637.06
1999 Mercury MountaineerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$364.13	Shop/Dealer Price$435.51 - $620.75
2000 Mercury MountaineerV8-5.0L	Service typePower Steering Pump Replacement	Estimate$369.83	Shop/Dealer Price$443.12 - $633.00

Show example Mercury Mountaineer Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Mercury mechanics

Real customer reviews from Mercury owners like you.

Excellent Rating

(208)

Rating Summary

196

6

1

1

4

196

6

1

1

4

SEE REVIEWS NEAR ME

Alexander

5 years of experience

126 reviews

Request Alexander

Alexander

5 years of experience

Request Alexander

by Kevin Thomtkins

Mountaineer 2005 - Car is making a noise - Reynoldsburg, OH

He was friendly and very professional. I will recommend him to anyone I know that having car problems.

Zachery

6 years of experience

14 reviews

Request Zachery

Zachery

6 years of experience

Request Zachery

by Ed Kravitz

Mountaineer 2002 - Brake Caliper - Columbus, OH

Outstanding

Chris

5 years of experience

30 reviews

Chris

5 years of experience

by Frederick Pritchett

Mountaineer 1998 - Door does not lock or open - Griffin, GA

Informative and Professional.

Elias

11 years of experience

46 reviews

Elias

11 years of experience

by Michael Loprete

Mountaineer 2002 - Alternator - Staten Island, NY

Awesome great experience

Excellent Rating

(208)

Rating Summary

196

6

1

1

4

196

6

1

1

4

SEE REVIEWS NEAR ME

Recent articles & questions

How Long Does a Power Steering Pump Last?

In In a hydraulic power steering system, which is what the vast majority of cars on the road today use, fluid must be pumped through a series of lines and hoses to the steering rack. That is done by the...

How to Lower Your Monthly Car Payment

When you find your budget tightening, you start to analyze your expenditure in an effort to loosen the proverbial noose of debt. You will find that some expenses are mandatory, some without cheaper substitutes and some things you can do...

Driving With ABS in Snow and Ice

The anti-lock braking system, referred to as ABS, does not work as effectively in snow, but does retain mild effectiveness on icy roads.

Antitheft light flashing on dashboard

It sounds like the ignition switch has gone amiss. There is an antenna built into it to detect the proper key. If that malfunctions, your Anti-Theft Light will come on. The key not turning is a different problem. It is...

My check engine light came on with code P0303 (Misfire in the 3rd Cylinder), Can I drive it until next Wednesday without damage?

To replace the spark plugs for all cylinders will be in the $200 to $300 dollar range depending on location parts and labor pricing. The price does not include additional parts or labor.

My dash electric system is shot. Any Ideas what to fix?

Hi There, It sounds like your instrument cluster needs to be replaced. Like many other elements of your vehicle, the modern instrument cluster is electronic, and requires voltage in order to operate. The instrument cluster consumes less power than batteries...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com