Mercedes-Benz 500SEL Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz 500SEL Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1992 Mercedes-Benz 500SELV8-5.0LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
1984 Mercedes-Benz 500SELV8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1985 Mercedes-Benz 500SELV8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1993 Mercedes-Benz 500SELV8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
Show example Mercedes-Benz 500SEL Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0

Theodore

16 years of experience
1601 reviews
Theodore
16 years of experience
Mercedes-Benz 500SEL V8-5.0L - Windows - Seattle, Washington
Excellent service from Theo Arrived on time Explained what he was doing Finished up with review of what he did and anything that needed to be done

Theodore

16 years of experience
1601 reviews
Theodore
16 years of experience
Mercedes-Benz 500SEL V8-5.0L - Windows - Seattle, Washington
Theodore was excellent! He was on time and did what he said. He even worked through a hailstorm!!

Horus

11 years of experience
122 reviews
Horus
11 years of experience
Mercedes-Benz 500SEL V8-5.0L - Power window is noisy - San Antonio, Texas
He knows a lot.

Herman

13 years of experience
86 reviews
Herman
13 years of experience
Mercedes-Benz 500SEL V8-5.0L - Ignition Cable (Spark plug wires) - Miami Beach, Florida
I have used his services twice and both times he has done a great job.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0
Number of Mercedes-Benz 500SEL services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Buy a New Car Below Sticker Price
When When you buy a new car from the car dealership, you want to get a better deal than they have advertised or displayed on the car, but negotiation isn’t a strong suit for every person. There are several ways...
P0175 OBD-II Trouble Code: P0175 System Too Rich (Bank 2)
P0175 code definition P0175 System Too Rich (Bank 2) What the P0175 code means P0175 indicates that the Engine Control Module (ECM)...
A Guide to Tire Safety
When When sitting behind the wheel of a car, there are two things that most drivers want: to reach their destination, and to do so as safely as possible. This means having a car that is in good condition, and...

Vibration in car body when in Drive

A few different items can cause the vehicle to have a vibration. The most likely would be a misfire, engine mount (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-engine-mount), or transmission mount. Most vibrations have a RPM range at which they are most noticeable. Increasing the idle...

My 2000 F-250 completely stalls randomly

The most common cause of random stalling on this vehicle is a failure in the camshaft position sensor or in the connection at the sensor. This causes the computer to lose the signal and stall. If there are other electrical...

USB connection problem for Acura TL 2009

Hello, thank you for writing in. First, make sure the USB cord you are using is in good condition. Even if it is not psychically damaged on the outside, the connection inside the conduit could be disconnected or damaged. The...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com