Lexus RX350 Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(4)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(4)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Lexus RX350 Water Pump Replacement is $618 with $198 for parts and $420 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2012 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$2217.10Shop/Dealer Price$2404.69 - $2807.28
2007 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$1078.76Shop/Dealer Price$1208.63 - $1567.94
2009 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$1078.76Shop/Dealer Price$1208.82 - $1568.27
2014 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$2115.29Shop/Dealer Price$2268.42 - $2645.17
2017 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$2205.39Shop/Dealer Price$2381.95 - $2826.96
2011 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$2115.29Shop/Dealer Price$2271.21 - $2650.04
2015 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$1008.56Shop/Dealer Price$1121.18 - $1428.06
2008 Lexus RX350V6-3.5LService typeWater Pump ReplacementEstimate$1078.76Shop/Dealer Price$1208.81 - $1568.25
Show example Lexus RX350 Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Lexus mechanics

Real customer reviews from Lexus owners like you.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0
Number of Lexus RX350 Water Pump Replacement services completed
44+
services done by our mechanics
TOTAL NUMBER OF EXPERT Lexus MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Buy a Good Quality Radar Detector
Have Have you ever been caught by radar and then nailed with a speeding ticket? One time is usually enough for people to always want to avoid this from happening in the future. A radar detector is an accessory you...
How to Quickly Cool Down a Hot Car
Knowing Knowing how to cool off a hot car that has been sitting in the heat and sun can save you the discomfort of having to sit in your vehicle's hot interior while driving to your destination. By taking a...
How Long Does a Trunk Striker Plate Last?
Most Most people use their trunk on a daily basis and never give a second thought to what it takes to make it function. A trunk is just like the front door of a home in regards to what it...

Why when I install a starter in truck it makes a lot of noise an then have to replace starter again the gears are grinded down

You may need to install a spacer to prevent the flywheel from touching the starter gear when the vehicle is running. This could be cause of both the noise and the worn down gears. If you need help with this...

Engine light on, misfire cylinder 6

The rough idle may be related to the low compression in cylinder #6. Low compression (https://www.yourmechanic.com/article/how-to-do-a-compression-test-by-robert-tomashek) will continue to cause a misfire until it is corrected. This will cause detonation and timing problems which is what indirectly causes the misfire....

The back wheels wont spin. Car was stuck in snow and i was hitting gas and the back wheels stopped moving. What could be wrong

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com