Jeep Patriot Car Thermostat Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(5)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(5)

Car Thermostat Replacement Service

How much does a Car Thermostat Replacement cost?

On average, the cost for a Jeep Patriot Car Thermostat Replacement is $165 with $70 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 Jeep PatriotL4-2.0LService typeCar Thermostat ReplacementEstimate$289.25Shop/Dealer Price$340.94 - $471.26
2014 Jeep PatriotL4-2.0LService typeCar Thermostat ReplacementEstimate$270.55Shop/Dealer Price$323.09 - $455.90
2017 Jeep PatriotL4-2.0LService typeCar Thermostat ReplacementEstimate$245.01Shop/Dealer Price$291.16 - $404.81
2010 Jeep PatriotL4-2.4LService typeCar Thermostat ReplacementEstimate$261.71Shop/Dealer Price$312.01 - $438.17
2009 Jeep PatriotL4-2.0LService typeCar Thermostat ReplacementEstimate$261.71Shop/Dealer Price$312.05 - $438.24
2016 Jeep PatriotL4-2.4LService typeCar Thermostat ReplacementEstimate$249.91Shop/Dealer Price$297.28 - $414.61
2007 Jeep PatriotL4-2.4LService typeCar Thermostat ReplacementEstimate$257.21Shop/Dealer Price$306.40 - $431.72
2015 Jeep PatriotL4-2.4LService typeCar Thermostat ReplacementEstimate$255.41Shop/Dealer Price$303.04 - $420.57
Show example Jeep Patriot Car Thermostat Replacement prices

What is an engine cooling system thermostat and how does it work?

The car's engine cooling system thermostat is a small valve within a cooling system passageway that opens and closes in response to the temperature of the circulating engine coolant. When your car is first started and the coolant is cold, the valve in the thermostat will be in the closed position, circulating the coolant flow only within the engine instead of flowing to the radiator, which allows the engine to warm up fast, promoting fuel efficiency, low emissions, and reduced engine deposits. Once the engine coolant reaches the design temperature, usually around 195 degrees, the valve will open and close as you drive in order to maintain a coolant temperature typically between 195 to 225 degrees Fahrenheit.

Thermostat

When to consider replacing the engine cooling system thermostat:

  • Engine overheats. A thermostat with the valve stuck closed is a common cause of engine overheating. However, since there are other causes of overheating, a mechanic will thoroughly inspect the cooling system prior to condemning the thermostat. Since it is usually not known how badly the engine overheated, the mechanic will also try to determine if there is evidence that the cylinder head gasket was blown. If so, it would be repaired prior to replacing the thermostat.
  • Temperature gauge reads too low or too high. Thermostats can get sticky, causing the engine temperature to stray from the optimal range. Your dash-mounted temperature gauge will notify you of this malfunction.
  • Cooling system repairs. All thermostats eventually fail. Therefore, if the cooling system is already open for major repairs, such as water pump or radiator replacement, it is recommended to install a new thermostat simply as insurance against future breakdown.

How do mechanics replace the engine cooling system thermostat?

  • Once the engine is completely cold, the radiator cap is loosened and enough coolant is drained from the radiator so the coolant level is below the thermostat housing.
  • The thermostat housing is removed and the thermostat and gasket are extracted. Note that some cars have more than one cooling system thermostat and both might need replacement.
  • All mounting surfaces on the thermostat housing are cleaned of old gasket material. A new gasket is applied and the thermostat is re-installed in the correct orientation and with the temperature sensing cylinder facing downward towards the engine.
  • The thermostat housing bolts are tightened to original equipment manufacturer (OEM) specifications using a calibrated inch-pound torque wrench.
  • The cooling system is refilled with the appropriate coolant type and the system is fully bled of all air.
  • The car engine is run until the normal operating temperature is reached, and while taking precautions with the hot coolant, the coolant level is rechecked while confirming there is flow through the radiator — either visually or with an infrared temperature gun. This will confirm the thermostat is open. Finally, the engine is checked for leaks.

Is it safe to drive with an engine cooling system thermostat problem?

No. If it has been determined that there is a thermostat problem, it should be repaired right away. Failure to do so can cause substantial and costly damage to the engine.

When replacing the engine cooling system thermostat keep in mind:

  • Engine overheating due to causes other than a faulty thermostat, will themselves damage a thermostat. Therefore, always replace the thermostat if the engine overheats, even if the thermostat was not the initial cause of the overheating.
  • The thermostat should be replaced anytime you have major work done on the coolant system. It is convenient and costs little during such repairs and insurance against future breakdown.
  • OEM thermostats are the best ones to use and you can request your mechanic to install only the OEM thermostat. Dealer supplied, OEM thermostats are sometimes more costly but are generally higher quality and specifically engineered for your car.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Jeep mechanics

Real customer reviews from Jeep owners like you.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0

Stacy

20 years of experience
330 reviews
Stacy
20 years of experience
Patriot 2008 - Thermostat - Stockbridge, GA
He does a great job and works very fast and makes sure the parts are working before he leaves.

Larry

15 years of experience
23 reviews
Larry
15 years of experience
Patriot 2014 - Tune-up - Columbus, OH
Larry was very thorough and did a fantastic job.

Jesse

15 years of experience
14 reviews
Jesse
15 years of experience
Patriot 2016 - Idler Pulley - Daytona Beach, FL
This the second time I used Jesse and I am completely satisfied. Highly recommend.

Jesse

15 years of experience
14 reviews
Jesse
15 years of experience
Patriot 2016 - Brake Pads - Daytona Beach, FL
This the second time I used Jesse and I am completely satisfied. Highly recommend.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0
Number of Jeep Patriot Car Thermostat Replacement services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Jeep MECHANICS
1300+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Alternator
Common signs include having to jump start the car frequently, dim lights when operating the vehicle, or the Battery Light coming on.
How to Determine the Total Interest Paid on a Car Loan
An An important aspect of any vehicle loan is the amount of interest you pay. If you want to compare loans to see which one is the better deal or just figure out how much interest you’ve paid in for...
How to Diagnose a Fluid Leak
If you see fluid leaking from your car, it's a problem. Determine where the leak is coming from, what type of fluid it is, and the best way to fix it.

Misfire still after tuneup

Hi there. If the spark plug, plug wire and ignition coil are good, then the issue may be inside of the engine. I would do a compression test first to see if there is any internal failure. If the compression...

Nothing turns on the car

From what you've described you may just have a bad battery connection. You should first have the vehicle jump started to see if it stays running and look for any lights that may have been left on. Once the jumper...

Screeching chirp noise engine - 1991 GMC K2500

Hey there. The A/C pulley bearing may be binding causing the chirping. Try spraying each belt one at a time with some water in a spray bottle. The noise will change or go away when the belt that is chirping...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com