Infiniti QX70 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(11)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(11)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Infiniti QX70 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 Infiniti QX70V6-3.7LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2014 Infiniti QX70V8-5.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2014 Infiniti QX70V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2016 Infiniti QX70V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2017 Infiniti QX70V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
Show example Infiniti QX70 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Infiniti mechanics

Real customer reviews from Infiniti owners like you.

Excellent Rating

(11)

Rating Summary
11
0
0
0
0
11
0
0
0
0

Luis

29 years of experience
93 reviews
Luis
29 years of experience
Infiniti QX70 V6-3.7L - Battery - Palatine, Illinois
Luis showed up early, is very knowledgeable and experienced, was meticulous with what he had to do to get into the battery compartment. Completed the work and gave me a report on his 50 point inspection with suggestions for what to keep my eye on going forward. Overall a great first experience.

Angel

17 years of experience
106 reviews
Angel
17 years of experience
Infiniti QX70 V6-3.7L - Brake Rotor/Disc Replacement (Rear) - Miami, Florida
Amazing ! As always

Cesar

9 years of experience
292 reviews
Cesar
9 years of experience
Infiniti QX70 V6-3.7L - Oil Change - Everett, Washington
Everything went pretty well.

Patrick

32 years of experience
369 reviews
Patrick
32 years of experience
Infiniti QX70 V6-3.7L - Pre-purchase Car Inspection - Las Vegas, Nevada
Patrick showed up right on time. He was so friendly and very thorough on my pre-purchase inspection! Even though he was inspecting a practically new car (4000 miles), he still spent an hour meticulously noting every detail. He was amazing, and I can't wait to use YourMechanic.com again!

Excellent Rating

(11)

Rating Summary
11
0
0
0
0
11
0
0
0
0
Number of Infiniti QX70 services completed
121+
services done by our mechanics
TOTAL NUMBER OF EXPERT Infiniti MECHANICS
900+
experts on our platform

Recent articles & questions

The Guide to Legal Car Modifications in New Jersey
ARENA Creative / Shutterstock.com Those who live in New Jersey or are planning to move to the area need to know the regulations concerning vehicle modifications to ensure their cars or trucks that have been modified are...
New Hampshire Parking Laws: Understanding the Basics
Drivers Drivers in New Hampshire need to know more than just the rules and laws of driving on the road. They also need to understand the parking laws so they know where they can and cannot park. Failure to adhere...
How to Replace a Coolant Vacuum Valve Switch
A vacuum line attaches to the vacuum switch in your car as part of the engine’s heating and cooling system. A faulty switch can break your heater.

My car is making a chirping noise when I accelerate and turn right. It stops when I brake.

At 30,000 miles you likely need a brake pad replacement. Your brake pads come with indicators attached (metal tabs that squeak when they are worn down). I would recommend a full brake inspection and go from there.

What's the fastest/cheapest way to diagnose an ABS light?

Hello there. The ABS on most vehicles requires a scanner with ABS testing capabilities. You will need to have the system scanned and codes received and diagnosed in order to learn what is the problem. If you want to have...

My Nissan Altima 2011 SL, the slip indicator light stays on while I'm driving and the car won't go above 2-3 rpm. It will make lurching movements and slow itself down

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com