Acura Vigor Front Crankshaft Seal Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(4)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(4)

Front Crankshaft Seal Replacement Service

How much does a Front Crankshaft Seal Replacement cost?

On average, the cost for a Acura Vigor Front Crankshaft Seal Replacement is $1218 with $294 for parts and $924 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1993 Acura VigorL5-2.5LService typeFront Crankshaft Seal ReplacementEstimate$1610.58Shop/Dealer Price$1799.06 - $2270.93
1992 Acura VigorL5-2.5LService typeFront Crankshaft Seal ReplacementEstimate$1551.11Shop/Dealer Price$1719.19 - $2175.76
1994 Acura VigorL5-2.5LService typeFront Crankshaft Seal ReplacementEstimate$1551.11Shop/Dealer Price$1719.48 - $2176.27
Show example Acura Vigor Front Crankshaft Seal Replacement prices

What is the Front Crankshaft Seal all about?

A number of mechanisms must work together to make your vehicle move forward. One of the most important is the crankshaft, which converts rotary into linear motion; i.e., it transforms the force created by the engine's pistons moving up and down into a force that moves in a circular motion that causes a car’s wheel to turn. Enclosed in what’s called a crankcase—the largest cavity in the engine block, just below the cylinders—the crankshaft must be completely lubricated, essentially submerged in oil, to spin nearly friction-free and do its job properly.

Consequently, there are seals located at either end of the crankshaft that allow it to spin freely and keep engine oil from escaping the engine block, as well as prevent contaminants and other debris from entering and causing damage to the mechanism. Since there are two ends of the crankshaft, there are two types of seals: the front crankshaft seal and the rear crankshaft seal, also known as the front main and rear main seals.

Keep in mind:

  • Loss of oil will eventually cause serious internal engine damage.
  • Inspect the sealing surface of the crankshaft or the crankshaft pulley (depending on the engine design) for damage when replacing the crankshaft seal.
  • Oil degrades rubber components.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The crankshaft damper and timing belt is removed
  • The crankshaft seal is removed and a new one installed
  • The timing belt and cover along with crankshaft damper is reinstalled
  • The engine accessory belts are installed and the vehicle is lowered off of the jack stands

Our recommendation:

One of the most important parts of your car, crankshaft seals are typically made from a durable material, such as a synthetic rubber or silicone, designed to handle the extreme pressure and temperatures as well as the caustic chemicals in your engine oil. Because they are exposed to such abuse, main seals are subject to a lot of wear and tear. And whether you are talking a front or rear main seal, replacement is the only cure when one malfunctions.

The good news is that the seals are relatively inexpensive components. The bad news is that neither is easy to replace.

Front seal: The front seal is located behind the main pulley that drives all the belts, which is, of course, always spinning. The main pulley throws any leaking oil out in a big circle. It can get thrown up on the alternator, steering pump, belts, in short anything attached to the front of the engine and cause a real mess and eventually some serious damage. Consequently, it has to be removed along with many of the components attached to the front of the block to replace the front main seal.

Rear seal: The rear crankshaft seal is placed along with the transmission; therefore, the process of replacing it requires the removal of transmission, as well as the clutch and flywheel assembly. This is a very involved job.

What common symptoms indicate you may need to replace the Front Crankshaft Seal?

  • Oil leaking from the front crank pulley.
  • Oil dripping from the bottom of the clutch housing, where the block and transmission meet.
  • Clutch slip caused by oil spraying on the clutch.

How important is this service?

Letting either crankshaft seal continue to leak can be detrimental to your vehicle’s continued operation. Besides the maladies caused by driving around with little to no oil flowing in the engine, the faulty seal will be spread oil through the engine bay and undercarriage of your car as you drive, a mess that is difficult to clean up and can be a fire hazard. Replacing is better addressed sooner than later.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Acura mechanics

Real customer reviews from Acura owners like you.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0

Jason

18 years of experience
429 reviews
Jason
18 years of experience
Acura Vigor L5-2.5L - Oil Change - San Jose, California
My 1993 Acura had been in desperate need for an oil change, and I have been totally dragging my feet, despite knowing better. On the evening of my appointment, Jason called me around 6:45PM, telling me that he was in the Blossom Hill area and would be a bit tardy getting to me. Sure enough, he arrived at my designated location promptly after that, and started with my vehicle. Jason was incredibly thorough, examined everything, communicated to me everything he found, and took care of the scheduled oil and filter change like a pro. Turns out that I'm gonna be in the market for a new water pump: Guess who I'm gonna book to fix it once I save up the amount? =)

Jerel

12 years of experience
125 reviews
Jerel
12 years of experience
Acura Vigor L5-2.5L - Oil Change - Raleigh, North Carolina
Very professional and knowledgable. Will definitely use again!!

Erick

11 years of experience
182 reviews
Erick
11 years of experience
Acura Vigor L5-2.5L - Brakes, Steering and Suspension Inspection - San Jose, California

Michael

9 years of experience
9 reviews
Michael
9 years of experience
Acura Vigor L5-2.5L - Car is not starting - Decatur, Georgia
Great service, was very nice and professional.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0
Number of Acura Vigor services completed
44+
services done by our mechanics
TOTAL NUMBER OF EXPERT Acura MECHANICS
1000+
experts on our platform

Recent articles & questions

Rules of the Road For Indiana Drivers
When When driving on the roadways, there are many rules that you have to follow. While many are based on common sense, others are in place for added safety and protection. Even though you are familiar with the laws in...
How Long Does a Variable Valve Timing (VVT) Switch Last?
Having Having a smooth running car is no accident. A lot of different parts have to work in conjunction with each other for the engine to run smoothly. The variable valve timing (VVT) system has a lot to do with...
How Car Suspension Systems Work
On the surface it appears the suspension of a car has a pretty straightforward job. If the bumps end up being...

I have a code P2119

Hi...Diagnostic Trouble Code P2119 (https://www.yourmechanic.com/article/throttle-actuator-control-throttle-body-range-performance-by-robert-kulp) indicates that there is a fault in your car's Electronic Throttle Control System. Electronically controlled throttles found on most modern vehicles utilize PCM programming to set and monitor the throttle position. Typically, the problem causing...

Fuel problem

Hello. A fuel system leak such as the one you describe can be caused by a few different things. The injectors are pulsed on and off by the engine computer. If you have already replaced it then it may be...

2008 chevy tahoe hybrid check engine light on

Generally, the check engine light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) comes on when something fairly serious is going on with the vehicle. This can happen for many different reasons such as a faulty mass air flow sensor, a faulty O2 sensor, a bad catalytic...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com