Popular articles

The check engine light is tied into your car’s onboard diagnostics system, and it’s designed to light up (usually in yellow) whenever...

Car AC refrigerant has to be recharged occasionally. Add more refrigerant to your AC system to keep your car cool in hot weather.

An An axle seal is the part of the vehicle that connects the axle to the rear differential, or the transmission. The purpose of the axle seal is to keep transmission fluid from leaking. Depending on the size of the...

P2068 P2068 trouble code definition Fuel Level Sensor “B” Circuit High What the P2068 code means This code indicates the fuel level sensor is indicating a higher than expected voltage. The higher the value the more fuel is in the...

If the AC is cutting on and off rapidly, unable to cool the cabin, or failing to turn on the compressor, you should replace your AC pressure switch.

Diagnostic Diagnostic Trouble Code (DTC): P0462 P0462 code definition When a vehicle’s PCM (Powertrain Control Module) logs a P0462 trouble code, it’s because its fuel level sensor is no longer taking correct readings. What the P0462 code means The way...

The The purpose of a sun visor is to protect the eyes of the driver and passenger from the glare of the sun. Over time, a sun visor can become damaged or worn down and require replacement. You can replace...

P0236 code definition Turbocharger Boost Sensor A Circuit Range/Performance What the P0236 code means P0236 is an OBD-II generic code that is...

Common signs include the vehicle entering "limp" mode, having difficulty shifting, and its engine RPM being higher than it should be.

P000A code definition This code is known as ‘A’ Camshaft Position Slow Response Bank 1. You may also see a 00010 fault...

P2195 trouble code definition O2 Sensor Signal Stuck Lean Bank 1 Sensor 1 What the P2195 code means P2195 is an OBD-II...

While it is safe to drive with an EVAP system leak, it causes excess car pollution. Fixing the problem is often as simple as tightening the gas cap.

Common signs include the Traction Control Light coming on, steering wheel feeling loose, and the car driving differently after a front end alignment.

Common signs of a faulty vacuum brake booster check valve include the brake pedal being difficult to engage, feeling spongy, or not working at all.

P000B means that the ECM has detected a fault with the position and timing of the camshaft due to a loose fuel cap, or low oil pressure.

If your car steering wheel shakes or shudders when turning, it could be the tires, power steering, or steering damper.

Older cars usually have to use conventional motor oil instead of synthetic motor oil. Switching to synthetic can cause engine leaks or engine damage.

P0868 means there the transmission fluid pressure is too low. This is likely due to a leak, malfunctioning sensor, or overheating.

P2228 code definition Barometric pressure circuit low What the P2228 code means This trouble code indicates that the powertrain control module has...

P2197 code definition O2 Sensor Signal Stuck Lean Bank 2 Sensor 1 What the P2197 code means This code is usually an...

P0733 Code Definition Gear 3 incorrect ratio is the technical definition of the P0733 trouble code What the P0733 code means The...

The heater valve is integral to a vehicle’s cooling system. Replacing one requires a new valve, some basic tools, and fresh coolant.

The center support bearing for the driveshaft is simple in design and function. It can be difficult to replace due to the driveshaft's complex build.

P0744 code means there is an abnormality in the torque converter clutch circuit often due to transmission failure or internal blockages.

Common signs include a ticking noise coming from the engine, an engine that won't turn over, engine misfires, and oil leaking in front of the motor.