Volkswagen Atlas Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(13)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(13)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Volkswagen Atlas Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2020 Volkswagen AtlasL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2022 Volkswagen AtlasV6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2018 Volkswagen AtlasL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2019 Volkswagen AtlasL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2020 Volkswagen AtlasV6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2021 Volkswagen AtlasV6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2022 Volkswagen AtlasL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2021 Volkswagen AtlasL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Volkswagen Atlas Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Volkswagen mechanics

Real customer reviews from Volkswagen owners like you.

Excellent Rating

(13)

Rating Summary
12
1
0
0
0
12
1
0
0
0

Chris

22 years of experience
2239 reviews
Chris
22 years of experience
Volkswagen Atlas V6-3.6L - Oil Change - Irvine, California
Very Professional, clean, and efficient

James

31 years of experience
699 reviews
James
31 years of experience
Volkswagen Atlas V6-3.6L - Oil Change - Irvine, California
Very Friendly and knowledgeable

Tinashe

13 years of experience
621 reviews
Tinashe
13 years of experience
Volkswagen Atlas V6-3.6L - Battery - Decatur, Georgia
Very friendly and seemed very knowledgeable.

Claud

8 years of experience
490 reviews
Claud
8 years of experience
Volkswagen Atlas V6-3.6L - Tire Rotation - Southfield, Michigan
Quick, efficient, and professional service

Excellent Rating

(13)

Rating Summary
12
1
0
0
0
12
1
0
0
0
Number of Volkswagen Atlas services completed
143+
services done by our mechanics
TOTAL NUMBER OF EXPERT Volkswagen MECHANICS
1000+
experts on our platform

Recent articles & questions

Top 10 Ways to Make Your Car More Green
Every car produces greenhouse gases. You can reduce your car's environmental impact with tune-ups, filling the tires, and making your car lightweight.
Symptoms of a Bad or Failing Transmission Speed Sensor
Common signs include harsh or improper shifting, cruise control not working, and the Check Engine Light coming on.
P0629 OBD-II Trouble Code: Fuel Pump "A" Control Circuit High
P0629 means there is an issue with the "A" control circuit in the fuel pump often due too bad connectors/wires or a defective CAN bus.

Grinding from rear brakes

Hi there. Sounds to me that your brake pads have worn past their limit causing the metal base to press against the brake rotor which is leading to metal on metal contact. A brake service is due for your car....

blown head gasket?

To answer your last question first, manufacturers of motor vehicles, that would include all of the army of engineers, scientists, and other high trained trained specialists, almost as a rule do not recommend the use of aftermarket "quick fixes", in...

96 mustang automatic will go in reverse but not drive the rear seal was replaced what could be wrong

Sometimes it seems like doing repairs on older cars is like opening Pandora's box. Failure of the transmission shouldn't have anything to do with replacement of the rear seal, but it seems it has. It could be that simply draining...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com