Pontiac Grand Am Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(12)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(12)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Pontiac Grand Am Water Pump Replacement is $237 with $97 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2003 Pontiac Grand AmV6-3.4LService typeWater Pump ReplacementEstimate$446.02Shop/Dealer Price$508.32 - $683.86
2004 Pontiac Grand AmV6-3.4LService typeWater Pump ReplacementEstimate$433.41Shop/Dealer Price$493.23 - $666.92
1994 Pontiac Grand AmL4-2.3LService typeWater Pump ReplacementEstimate$594.16Shop/Dealer Price$656.10 - $831.47
1992 Pontiac Grand AmV6-3.3LService typeWater Pump ReplacementEstimate$559.12Shop/Dealer Price$626.15 - $818.49
1998 Pontiac Grand AmV6-3.1LService typeWater Pump ReplacementEstimate$375.01Shop/Dealer Price$435.60 - $609.86
1991 Pontiac Grand AmL4-2.3LService typeWater Pump ReplacementEstimate$637.95Shop/Dealer Price$700.84 - $876.92
1996 Pontiac Grand AmV6-3.1LService typeWater Pump ReplacementEstimate$389.61Shop/Dealer Price$448.92 - $622.24
1990 Pontiac Grand AmL4-2.3LService typeWater Pump ReplacementEstimate$637.95Shop/Dealer Price$700.45 - $876.23
Show example Pontiac Grand Am Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Pontiac mechanics

Real customer reviews from Pontiac owners like you.

Excellent Rating

(12)

Rating Summary
10
1
0
1
0
10
1
0
1
0

Excellent Rating

(12)

Rating Summary
10
1
0
1
0
10
1
0
1
0
Number of Pontiac Grand Am Water Pump Replacement services completed
132+
services done by our mechanics
TOTAL NUMBER OF EXPERT Pontiac MECHANICS
800+
experts on our platform

Recent articles & questions

How to Clean and Maintain Windshield Washers
When When dirt or debris lands on your windshield while driving, your immediate reaction would be to use the wiper fluid spray to clear it. If your car’s wiper fluid doesn't spray properly, it may have clogged wiper fluid nozzles...
How to Buy a Good Quality Brake Hose
Brake Brake hoses, sometimes used interchangeably with the term “brake lines,” carry brake fluid between the master cylinder and the wheel cylinder or brake calipers - depending upon the type of brakes you have. The pressure from the brake fluid...
Symptoms of a Bad or Failing Console Light Bulb
If your car's center console light is dim, flickering, or not working at all, you may need to replace the console light bulb.

Fuel rail leaking

Hello. I have seen this many times on this engine. The most common fuel leak on the fuel rail is the fuel injector O-rings. These O-rings that go between the rail and the injectors tend to rot out over time...

does my key have to be programmed to new ecm

There is a long, long decision tree in the Factory Service Manual (FSM) to deal with issues like the one you have and it is only at the very end of that tree, that you consider ECM failure. Indeed, ECM...

Car will not engage in drive

Claimed by John Hege

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com