Oldsmobile Intrigue Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(3)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(3)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Oldsmobile Intrigue Water Pump Replacement is $326 with $130 for parts and $196 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1999 Oldsmobile IntrigueV6-3.5LService typeWater Pump ReplacementEstimate$549.68Shop/Dealer Price$637.89 - $891.18
2001 Oldsmobile IntrigueV6-3.5LService typeWater Pump ReplacementEstimate$537.07Shop/Dealer Price$622.80 - $874.24
2000 Oldsmobile IntrigueV6-3.5LService typeWater Pump ReplacementEstimate$537.07Shop/Dealer Price$622.84 - $874.30
1998 Oldsmobile IntrigueV6-3.8LService typeWater Pump ReplacementEstimate$464.99Shop/Dealer Price$532.74 - $730.14
2002 Oldsmobile IntrigueV6-3.5LService typeWater Pump ReplacementEstimate$537.07Shop/Dealer Price$624.90 - $877.91
1999 Oldsmobile IntrigueV6-3.8LService typeWater Pump ReplacementEstimate$464.99Shop/Dealer Price$532.93 - $730.48
Show example Oldsmobile Intrigue Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Oldsmobile mechanics

Real customer reviews from Oldsmobile owners like you.

Excellent Rating

(3)

Rating Summary
2
1
0
0
0
2
1
0
0
0

Excellent Rating

(3)

Rating Summary
2
1
0
0
0
2
1
0
0
0
Number of Oldsmobile Intrigue Water Pump Replacement services completed
33+
services done by our mechanics
TOTAL NUMBER OF EXPERT Oldsmobile MECHANICS
300+
experts on our platform

Recent articles & questions

The Best Used Cars to Buy If You Get Motion Sickness
For For people that suffer from motion sickness, even on the shortest car trip, riding in a vehicle can prove to be unbearable. What’s great is that there are a number of cars on the market that can help to...
P0394 OBD-II Trouble Code: Camshaft Position Sensor "B" Circuit Intermittent (Bank 2)
P0394 means the camshaft sensor circuit B that is in engine bank 2 produced an intermittent and incorrect voltage reading
P0069 OBD-II Trouble Code: Manifold Absolute Pressure/Barometric Pressure Correlation
P0069 P0069 Code Definition Manifold Absolute Pressure/Barometric Pressure Correlation What the P0069 code means What this code means is that the Powertrain Control Module is detecting contradictory readings from the manifold absolute pressure sensor and the barometric pressure sensor. What...

Bad u-joint making noise.

Hello. As a Jeep ages, many of the front end parts can wear out and become loose. From the description of the noise it sounds like you either have a worn out front shock or you may have a bad...

windsheid wiper only works on fast speed

It is very likely that you are having an issue with your wiper switch as this is the part that controls the speed at which your wipers operate. I would recommend enlisting in the assistance of a quaified professional to...

cleaning the idle air control valve on a 01 nissan altima 2.4l

If you are having problems with the idle air control valve you may have to replace it. If you just want to clean it you would need to have it removed or use an induction cleaner tool to pull cleaner...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com