Nissan Versa Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(646)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(646)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Nissan Versa Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 Nissan VersaL4-1.6LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2012 Nissan VersaL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2009 Nissan VersaL4-1.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2014 Nissan VersaL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2016 Nissan VersaL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2007 Nissan VersaL4-1.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2017 Nissan VersaL4-1.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2010 Nissan VersaL4-1.8LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Nissan Versa Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Nissan mechanics

Real customer reviews from Nissan owners like you.

Excellent Rating

(646)

Rating Summary
613
17
4
5
7
613
17
4
5
7

Ian

15 years of experience
133 reviews
Ian
15 years of experience
Nissan Versa L4-1.6L - Car starts and then dies - Mukilteo, Washington
Will use again when needed!

Richard

21 years of experience
461 reviews
Richard
21 years of experience
Nissan Versa L4-1.8L - Car starts and then dies - Fairburn, Georgia
Richard was very detailed and I really enjoyed the video that was provided.

Tim

30 years of experience
45 reviews
Tim
30 years of experience
Nissan Versa L4-1.8L - Axle / CV Shaft Assembly Replacement (Driver Side Front) - Riverdale, Georgia
My appointment got off to a rocky start. Tim was running late because previous job ran long and the parts shop couldn't find my order. I was glad to see him when he finally arrived. He was courteous and professional and got right to work. He finished an 8 hour job in 5 hours and recommended an alignment. I scheduled an alignment for the next day and so far so good, my car is running great.

Brandon

20 years of experience
773 reviews
Brandon
20 years of experience
Nissan Versa L4-1.6L - Brake Pads Replacement (Front) - Orlando, Florida
I had issue with this service, after the break pads were replaced they start making a horrendous sound everytime I stopped, but the warranty cover it and all point out to the actual parts not the labor. Brandon did a good job but the parts were defective apparently.

Excellent Rating

(646)

Rating Summary
613
17
4
5
7
613
17
4
5
7
Number of Nissan Versa services completed
7106+
services done by our mechanics
TOTAL NUMBER OF EXPERT Nissan MECHANICS
1500+
experts on our platform

Recent articles & questions

How to Decide on a Car Paint Color
Are Are you repainting an old vehicle? Or are you trying to choose a paint color for your next car? There are a number of factors to consider when choosing a paint color for your car, and if the job...
P2294 OBD-II Trouble Code: Fuel Pressure Regulator 2 Control Circuit/Open
P2294 code definition Fuel Pressure Regulator 2 Control Circuit/Open What the P2294 code means When trouble code P2294 sets, it means that...
P2529 OBD-II Trouble Code: Vacuum Reservoir Press Sensor Circuit Intermmittent
P2529 code means the vacuum reservoir pressure sensor is not sending an input signal due to a defective vacuum sensor, pump, hose, valve, or a leak.

How do I fix the timing when it has jumped timing

There is no easy way to correct a jumped timing belt. You will need to disassemble a portion of the engine to gain access to the belt tensioner, so you can move the belt back into position. I suggest replacing...

Car misfires after distributor, rotors, plugs, plug wires replacements. 1999 GMC Savana 3500

Although the person who serviced your vehicle the first time did not repair the issue, I think he might be correct about the fact that it could be an intake manifold gasket (https://www.yourmechanic.com/services/intake-manifold-gaskets-replacement) or a fuel pump issue (https://www.yourmechanic.com/services/fuel-pump-replacement). You...

Loud noise from passenger side of engine.

Thank you for the link of the noise that you are hearing. The noise sounds like the timing chain is slapping the timing chain cover. Check the tensioner and make sure that it is tight. If the timing chain tensioner...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com