Mitsubishi Mirage Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(71)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(71)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Mitsubishi Mirage Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1995 Mitsubishi MirageL4-1.8LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1989 Mitsubishi MirageL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2001 Mitsubishi MirageL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2017 Mitsubishi MirageL3-1.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2018 Mitsubishi MirageL3-1.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1994 Mitsubishi MirageL4-1.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1986 Mitsubishi MirageL4-1.5LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1987 Mitsubishi MirageL4-1.5LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Mitsubishi Mirage Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mitsubishi mechanics

Real customer reviews from Mitsubishi owners like you.

Excellent Rating

(71)

Rating Summary
66
4
0
0
1
66
4
0
0
1

Robert

20 years of experience
1111 reviews
Robert
20 years of experience
Mitsubishi Mirage L4-1.8L - Camshaft Position Sensor - Denver, Colorado
Robert Farrow is a really nice person 100% professional should be more than 5 stars.

Robert

20 years of experience
1111 reviews
Robert
20 years of experience
Mitsubishi Mirage L4-1.8L - Check Engine Light is on - Denver, Colorado
He was genuine

Philip

14 years of experience
17 reviews
Philip
14 years of experience
Mitsubishi Mirage L3-1.2L - Brake Pads Replacement (Front) - San Antonio, Texas
Philip worked on my wife's car did an awesome job...took time to check out another possible issue with mine. Excellent and Trustworthy.

Jason

32 years of experience
530 reviews
Jason
32 years of experience
Mitsubishi Mirage L3-1.2L - Pre-purchase Car Inspection - San Jose, California
Arrived early. Was very professional and nice.

Excellent Rating

(71)

Rating Summary
66
4
0
0
1
66
4
0
0
1
Number of Mitsubishi Mirage services completed
781+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mitsubishi MECHANICS
700+
experts on our platform

Recent articles & questions

Different Types of Drivers on the Road
There There are 210 million people with a driver’s license in the US. As you sit in traffic - yet again - you’re pretty certain that all 210 million of those people are on road with you. “Those people” include...
How to Prepare for the Nebraska Driver’s Written Test
Being Being able to drive means freedom, and if you’ve been dreaming of the day that you could actually get behind the wheel, you know that the state of Nebraska requires a few things before you can actually drive. Namely,...
How to Prepare for the North Dakota Driver’s Written Test
Until Until you take and pass your North Dakota driver’s written test, you will not be able to get your permit or take the road test. The written exam is an important part of the process as it allows the...

Sensor messed up

Hello. There should be a Check Engine warning light on the dash display. It could also be a loose connection if you recently had exhaust work done. If you have any failure in the catalyst sensors or wiring, it should...

Sulfur smell while flooring 2011 V6 Mitsubishi Outlander

First thing--start buying your gas somewhere else. Sulfur is created by sulfur burning in the gas and you are getting bad gas that has sulfur in it. That's the only thing. The only other thing that can make sulfur in...

When I start my car I here a howling sound. I was thinking this might be the drive belt?

Hello there, many faults will cause a howling noise when your engine is running on your 2000 Chrysler LHS. The most common faults are the drive belt, belt tensioner, idler pulley, seized accessories, timing belt, or water pump. Many of...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com