Mercury Cougar Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(75)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(75)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Mercury Cougar Water Pump Replacement is $249 with $95 for parts and $154 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2001 Mercury CougarV6-2.5LService typeWater Pump ReplacementEstimate$557.32Shop/Dealer Price$633.38 - $846.98
2000 Mercury CougarL4-2.0LService typeWater Pump ReplacementEstimate$433.07Shop/Dealer Price$503.21 - $709.08
1997 Mercury CougarV8-4.6LService typeWater Pump ReplacementEstimate$546.44Shop/Dealer Price$624.17 - $850.23
1994 Mercury CougarV8-4.6LService typeWater Pump ReplacementEstimate$546.44Shop/Dealer Price$624.17 - $850.23
1991 Mercury CougarV8-5.0LService typeWater Pump ReplacementEstimate$477.27Shop/Dealer Price$560.10 - $800.36
2002 Mercury CougarV6-2.5LService typeWater Pump ReplacementEstimate$541.10Shop/Dealer Price$614.28 - $825.72
2001 Mercury CougarL4-2.0LService typeWater Pump ReplacementEstimate$433.07Shop/Dealer Price$503.25 - $709.16
1992 Mercury CougarV8-5.0LService typeWater Pump ReplacementEstimate$491.87Shop/Dealer Price$573.27 - $812.45
Show example Mercury Cougar Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercury mechanics

Real customer reviews from Mercury owners like you.

Excellent Rating

(75)

Rating Summary
66
6
2
0
1
66
6
2
0
1

Bill

30 years of experience
52 reviews
Bill
30 years of experience
Cougar 2000 - Loud clicking noise when I turn the car - Littleton, CO
very positive

Tinashe

10 years of experience
534 reviews
Tinashe
10 years of experience
Cougar 2001 - Tune-up - Alpharetta, GA
He arrived on time, informed me about what he would do to tune-up my car and was very professional and polite.

Excellent Rating

(75)

Rating Summary
66
6
2
0
1
66
6
2
0
1
Number of Mercury Cougar services completed
825+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercury MECHANICS
600+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Power Brake Booster
If you notice the brake pedal is difficult to push, causes the engine to stall, or takes longer to stop the car, the power brake booster is failing.
How Long Does a Track Bar Last?
The The track bar is part of your car's suspension system and is located underneath your vehicle. The bar is attached to a suspension link that provides a lateral location for the axle. The suspension allows the wheels to move...
Disabled Driver Laws and Permits in Kansas
Every Every state treats disability driver laws differently. It is important to be acquainted with not only your state’s laws and permits for disabled drivers, but for other states as well. How do I know if I am eligible for...

Oxygen sensor overheating

I think what you are talking about is an oxygen sensor (O2) heater malfunction. Modern O2 sensors use a heater element with a dedicated circuit to bring the sensor up to operating temperature quickly. Once at operating temperature, the powertrain...

DBC light is lit up on the dash (red).

Hi there. The Downhill Brake Control (DBC) light is on for either the system is active by having pushed the on button or the controller under the dash is malfunctioning. First look for the button that turns on the downhill...

P2196 OBD-II Trouble Code. came and went in 24 hours. 4 starts.

If the mechanic tested the output (functioning) of the oxygen sensor, especially according to the protocol at this link (https://www.yourmechanic.com/article/p2196-obd-ii-trouble-code-o2-sensor-signal-stuck-rich-bank-1-sensor-1-by-robert-kulp) and found that the sensor was non functioning at that time, what you might be experiencing is a "failing" oxygen...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com