Mercury Cougar Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Mercury Cougar Power Steering Pump Replacement is $180 with $85 for parts and $95 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1985 Mercury CougarL4-2.3L Turbo	Service typePower Steering Pump Replacement	Estimate$412.91	Shop/Dealer Price$493.64 - $708.83
1989 Mercury CougarV6-3.8L Turbo	Service typePower Steering Pump Replacement	Estimate$439.71	Shop/Dealer Price$511.20 - $662.55
1999 Mercury CougarV6-2.5L	Service typePower Steering Pump Replacement	Estimate$374.34	Shop/Dealer Price$440.47 - $593.76
1992 Mercury CougarV6-3.8L	Service typePower Steering Pump Replacement	Estimate$335.22	Shop/Dealer Price$395.65 - $538.70
1982 Mercury CougarV8-4.2L	Service typePower Steering Pump Replacement	Estimate$407.91	Shop/Dealer Price$490.68 - $707.41
1981 Mercury CougarL6-3.3L	Service typePower Steering Pump Replacement	Estimate$303.43	Shop/Dealer Price$360.06 - $498.41
1977 Mercury CougarV8-5.0L	Service typePower Steering Pump Replacement	Estimate$374.91	Shop/Dealer Price$453.52 - $667.12
1996 Mercury CougarV6-3.8L	Service typePower Steering Pump Replacement	Estimate$323.73	Shop/Dealer Price$382.54 - $524.38

Show example Mercury Cougar Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Mercury mechanics

Real customer reviews from Mercury owners like you.

Excellent Rating

(75)

Rating Summary

66

6

2

0

1

66

6

2

0

1

SEE REVIEWS NEAR ME

Bill

30 years of experience

52 reviews

Bill

30 years of experience

by Jeanne Kula

Cougar 2000 - Loud clicking noise when I turn the car - Littleton, CO

very positive

Tinashe

10 years of experience

534 reviews

Request Tinashe

Tinashe

10 years of experience

Request Tinashe

by Amanda Anderson

Cougar 2001 - Tune-up - Alpharetta, GA

He arrived on time, informed me about what he would do to tune-up my car and was very professional and polite.

Excellent Rating

(75)

Rating Summary

66

6

2

0

1

66

6

2

0

1

SEE REVIEWS NEAR ME

Recent articles & questions

5 Essential Things to Know About Car Alarms

Car Car alarms are an essential tool for keeping your vehicle safe from thieves. However, making sure you understand the options available can make a huge difference in how effective it is. Below, you’ll find five essential things to know...

P3401 OBD-II Trouble Code: Cylinder 1 Deactivation Intake Valve Control Circuit Open

P3401 P3401 trouble code definition Cylinder 1 Deactivation Intake Valve Control Circuit Open What the P3401 code means P3401 is an OBD-II generic code for the engine control module (ECM) detecting that the intake control solenoid for cylinder number 1...

What is the Automatic Transmission Mount all about?

How to repair an automatic transmission mount

What is a rocker switch and what uses do they have in cars?

A rocker switch is a type of on / off electrical switch that rocks back and forth on a pivot point between positions when pressed. When the switch is pressed, one side of the switch is raised, while the other...

Smoke from the dashboard, parking lights won't turn off

Hello. It sounds like there is a short in the wiring harness of the car. If the wiring comes into contact with other wiring, this may cause a short and smoke from the dashboard. This sometimes happens due to old...

I do not know where my brake booster vacuum line connects to my engine.

The HHR comes with two different motor options, so this complicates my answer a bit. Either way, the best method is to follow the hose at the brake vacuum booster to where it connects on the motor. Even better, simply...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com