Mercedes-Benz CLS400 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz CLS400 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2017 Mercedes-Benz CLS400V6-3.0L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2015 Mercedes-Benz CLS400V6-3.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2016 Mercedes-Benz CLS400V6-3.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example Mercedes-Benz CLS400 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(6)

Rating Summary
5
0
0
0
1
5
0
0
0
1

Mack

22 years of experience
114 reviews
Mack
22 years of experience
Mercedes-Benz CLS400 V6-3.0L Turbo - Oil Change - Burleson, Texas
Gre,at

David

13 years of experience
424 reviews
David
13 years of experience
Mercedes-Benz CLS400 V6-3.0L Turbo - Brake Pads Replacement (Front) - Marietta, Georgia
David continues to DELIVER!!!!

David

13 years of experience
424 reviews
David
13 years of experience
Mercedes-Benz CLS400 V6-3.0L Turbo - Oil Change - Marietta, Georgia
Always deliver!!!! Awesome experience!

Tinashe

13 years of experience
644 reviews
Tinashe
13 years of experience
Mercedes-Benz CLS400 V6-3.0L Turbo - Oil Change - Marietta, Georgia
Delivers every time! I can always count on this guy.

Excellent Rating

(6)

Rating Summary
5
0
0
0
1
5
0
0
0
1
Number of Mercedes-Benz CLS400 services completed
66+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Ambient Temperature Sensor (Switch)
Common signs include a faulty AC auto mode, inconsistent cooling, and incorrect outdoor temperature readings.
Rules of the Road For Alaska Drivers
While While most drivers understand the basic rules of the road since many of them are based on common sense, each state has different rules. The following are some of the road rules for Alaska drivers that may be different...
P0538 OBD-II Trouble Code: A/C Evaporator Temperature Sensor Circuit High
P0538 means that voltage readings from the A/C evaporator temperature sensor that are irregular due to a faulty temperature sensor or wiring.

Alternator reading low on voltage meter

I need to know where you're testing the voltage and what problem you are having. A proper way to test the for voltage is at the battery terminals with the car running. When the car is running you should read...

Blue smoke after starting the car

Blue smoke usually indicates oil getting into the combustion process - not a good thing. If you had your oil changed the day before, check the oil level to make sure it wasn't over-filled. If you car is accumulating some...

Thinking of buying a different car. I found one online and took it for a test drive. It has a few concerns. Is it worth investing?

Hi there. With the problems that you have mentioned, this could be an expensive fix, depending on what is wrong with the clicking sound and what is wrong with the transmission. The clicking sound is more of a CV Shaft...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com