Jeep FJ3A Car pulls in one direction Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6,592)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6,592)

Car pulls in one direction Inspection Service

How much does a Car pulls in one direction Inspection cost?

On average, the cost for a Jeep FJ3A Car pulls in one direction Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1961 Jeep FJ3AL4-2.2LService typeCar pulls in one direction InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1964 Jeep FJ3AL4-2.2LService typeCar pulls in one direction InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1962 Jeep FJ3AL4-2.2LService typeCar pulls in one direction InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1963 Jeep FJ3AL4-2.2LService typeCar pulls in one direction InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
Show example Jeep FJ3A Car pulls in one direction Inspection prices

Driving a car that pulls to one side is not only inconvenient, but it is also very dangerous. Maintaining constant pressure on the steering wheel to keep the car going straight is tiring and can pull your focus off the road. Plus, it can be very hard on your tires.

A pull to one side can be caused by a wide variety of issues -- everything from an underinflated tire to failed suspension parts.

Common reasons for this to happen:

Uneven Tire Pressure

Uneven tire pressure is a very common reason for a car to pull to one side. Lower pressure on one side changes the height of the tire, which causes the alignment to change. This is especially true if you have an underinflated rear tire. If the tire is underinflated, it will have increased rolling resistance which will make the pull to one side much more noticeable.

Over inflated tires are just as bad. This condition will also cause the alignment to change. An overinflated tire will cause the vehicle to push away from that tire, also creating abnormal tire wear.

You can see this in two ways:

  • An underinflated tire will show wear on the outer edges.
  • An overinflated tire will show wear down the center of the tire.

This is an easy fix: head to the local gas station and inflate all tires to their proper pressure. Tire pressure stipulations can usually be found on the driver’s side door jam. The optimal pressure is on a sticker. After you have inflated the tires back to their specifications, drive the vehicle to verify the pull is now gone.

Wheel Alignment

Another common cause of a car pulling to the side is a wheel that is out of alignment. Another symptom of misaligned wheels is uneven tread wear. Out-of-alignment wheels will quickly wear down and can lead to more serious issues if not addressed. You should have your vehicle aligned as soon as possible if this is the root cause of the pulling.

Alignment is not an adjustment of the wheels or tires, but of the suspension. A mechanic will adjust the suspension so that the angle of the tires is optimized and the tires make contact with the road according to the manufacturer specifications.

Brake Issues: Stuck Caliper, Collapsed Brake Hose, Unlubricated Slide Pins

Issues with the brake system can cause a vehicle to pull to one side. One of the most common brake issues is a stuck caliper. Brake calipers are powered by the hydraulic brake system and apply pressure to the brake pads to bring the car to a stop. If one of the calipers is stuck, the car will pull to that side.

Other brake issues that cause a car to pull include a collapsed brake hose, or slide pins that are in need of lubrication. Brake issues should be dealt with by a professional, as the braking system is a critical safety component of your car.

Bad Wheel Bearing

If you have a bad wheel bearing, there will probably be more serious symptoms present, but pulling to one side is also a warning sign.

Wheel bearings allow the friction-free rotation of the wheel hub assembly, providing smooth wheel rotation.

There are four wheel bearings on a vehicle, one at each wheel. When a wheel bearing wears out you will hear a grinding noise from the tire area, the steering wheel will sometimes shake, and the car will possibly pull to one side if it is starting to seize. This latter symptom often occurs long after you start hearing the grinding noise.

You should not drive your vehicle in this condition. Contact a mechanic immediately. Replacing a wheel bearing is a complicated repair and should be done by a professional.

Worn Suspension Components

At some point in your vehicle’s lifetime, most of the suspension will need replacing. Whether it is shocks or struts, ball joints, control arms or bushings, all the components wear out over time. As they become worn, they will often shift or lean to one side, especially during braking, which causes the car to pull to that side.

For example, a worn-out control arm bushing will shift when the brakes are applied, causing the vehicle to pull sharply to that side. Suspension parts tend to wear out slowly, so it is possible that you may not notice until they actually break.

The suspension is a key component of your car’s safety system and you should not drive it with broken or worn parts. An annual inspection of your suspension can help avoid surprises.

Worn Steering Linkage

A weak tie rod end will cause the steering wheel to shift to one side or the other while turning. If it gets extremely bad, the steering wheel could shake violently from side to side. Newer vehicles use a rack-and-pinion system that can sometimes be serviced. Older vehicles use a steering box and linkage system that is serviceable.

A broken or severely damaged steering linkage is extremely dangerous, as it could result in loss of control of the steering wheel. If you suspect any of these symptoms, have your car checked by a mechanic.

Torque Steer

Torque steer is when the car pulls to one side as the car initially accelerates. There can be several causes of this condition. Sometimes, loose steering components are the culprit. Other times, a broken motor mount is the cause. Too much slack in a tie rod, a failing lower control-arm bushing, or a ball joint with excess movement can all cause this problem.

You can test for this problem by putting your car in neutral and coasting it down the street. If the pull does not happen when coasting, your alignment is probably not the problem and torque steer could be the source of the issue.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the cause and source of the pulling issue, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How important is this service?

A car is not safe to operate under conditions where it is pulling to one side. Regardless of whether it is a brake issue, suspension issue, or a bad wheel bearing, these repairs require the expertise of a professional. Book a mechanic to perform a thorough inspection as soon as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Jeep mechanics

Real customer reviews from Jeep owners like you.

Excellent Rating

(6,592)

Rating Summary
6,251
185
36
24
96
6,251
185
36
24
96

Jose

16 years of experience
324 reviews
Jose
16 years of experience
Jeep Wrangler L4-2.5L - Car pulls in one direction - Fort Lauderdale, Florida
It was a pleasure working with Jose. Very professional and polite

Alexander

12 years of experience
54 reviews
Alexander
12 years of experience
Jeep Grand Cherokee V8-5.7L - Brakes, Steering and Suspension Inspection - Bowie, Maryland
N/a

Brian

18 years of experience
109 reviews
Brian
18 years of experience
Jeep Grand Cherokee V8-5.7L - Brake Pads Replacement (Front, Rear) - Atlanta, Georgia
Great job - super fast as well

Cameron

14 years of experience
95 reviews
Cameron
14 years of experience
Jeep Cherokee L6-4.0L - Car is hesitating and bucking - Puyallup, Washington
Second time I’ve had Cameron come out (2 separate issues) and am very please with the knowledge that this man shows. Can’t think of a better guy to work on my Jeep!!

Excellent Rating

(6,592)

Rating Summary
6,251
185
36
24
96
6,251
185
36
24
96
Number of Jeep services completed
72512+
services done by our mechanics
TOTAL NUMBER OF EXPERT Jeep MECHANICS
1300+
experts on our platform

Recent articles & questions

How Are High-Performance Ignition Systems Different from Standard Ones?
Once Once upon a time, there was only one type of ignition system. It used a distributor, points, a coil, and was subject to significant wear and tear. Then came the electronic ignition, which replaced the points with an electronic...
P2092 OBD-II Trouble Code: A Camshaft Position Actuator Control Circuit Low Bank 2
What What the P2092 code means? P2092 is an OBD-II generic code for the engine control module (ECM) detecting the A camshaft position actuator control circuit is low on bank 2. What causes the P2092 code? The ECM monitors the...
P0542 OBD-II Trouble Code: Intake Air Heater "A" Circuit High
P0542 trouble code means that there is an issue with the intake air heater “A” circuit high often due to faulty intake air relay or poor wiring

Convertible top won't go down in a 1994 BMW 325i

Hi. There is an emergency release lever under the back seat of your car. It disengages the motor from the tonneau cover so you can put the top up manually if need be. If the level has gotten pulled, you...

Idle rough when engine warm.

There are a few possible problems that could cause these symptoms. It could have a failed coolant temperature sensor, which reports the temperature of the engine to the engine control module. The engine control module uses this info to determine...

intermittent screeching coming from front right passenger wheel when accelerating above 20mph.

To be safe, check to make sure that you are not having a problem with the engine belt slipping and causing the squealing noise. Also, make sure the metal backing plate behind the rotor is not too close and rubbing...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com