Chevrolet K3500 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(13)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(13)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Chevrolet K3500 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1994 Chevrolet K3500V8-5.7LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1989 Chevrolet K3500V8-6.2L DieselService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1990 Chevrolet K3500V8-7.4LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Chevrolet K3500V8-5.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1995 Chevrolet K3500V8-5.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1998 Chevrolet K3500V8-6.5L Turbo DieselService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1997 Chevrolet K3500V8-5.7LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1991 Chevrolet K3500V8-5.7LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Chevrolet K3500 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(13)

Rating Summary
10
2
0
0
1
10
2
0
0
1

Nicholas

11 years of experience
303 reviews
Nicholas
11 years of experience
Chevrolet K3500 V8-7.4L - Car is making a noise - Houston, Texas
Identified the problem the second he heard the noise (no power steering fluid) , had the needed fluid on hand, filled it up and checked for leaks.

James

30 years of experience
925 reviews
James
30 years of experience
Chevrolet K3500 V8-7.4L - Car is not starting Inspection - Kissimmee, Florida
On time and did a great job.

Ben

18 years of experience
114 reviews
Ben
18 years of experience
Chevrolet K3500 V8-7.4L - Fuel Pump - Englewood, Colorado
Prompt, nice and intelligent.

Kenneth

37 years of experience
16 reviews
Kenneth
37 years of experience
Chevrolet K3500 V8-7.4L - Car is overheating - Englewood, Colorado
Very nice and competent!

Excellent Rating

(13)

Rating Summary
10
2
0
0
1
10
2
0
0
1
Number of Chevrolet K3500 services completed
143+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

How to Drive Uphill
Driving Driving on a flat surface does not put excess stress on your vehicle’s engine, but, traveling up steep inclines can lead to an overworked engine. However, there are a few techniques you can follow to lessen the stress on...
P0770 OBD-II Trouble Code: Shift Solenoid E Malfunction
P0770 means there is a malfunction of shift solenoid E on the transmission valve body, likely due to a faulty shift solenoid or issue with the fluid.
P0389 OBD-II Trouble Code: Crankshaft Position Sensor B Circuit Intermittent
P0389 means there is an issue with the crankshaft position sensor, likely due to the sensor having a bad wire or connector.

How do I adjust the remote start front defrost?

When the remote start front defrost feature is turned on, your front defroster will begin operating when the engine is turned on via remote start. To turn this feature on or off, follow these steps: 1. Press the Up/Down buttons...

Check Engine Light is on. Car idles high when put in drive or reverse and engine stalls when too much gas is applied.

Is there also a loud hissing or sucking noise and maybe a lean code stored in the engine control computer? The high idle sounds like there may be a problem with the idle air control valve or there may be...

Why is my temperature gauge going up and down?

Hi There, It sounds like you may have a sticky thermostat or potentially a cooling fan that may be working intermittently. The thermostat regulates the flow of the coolant in your car's engine and controls when the coolant flows in...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com