Buick Riviera Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(31)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(31)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Buick Riviera Water Pump Replacement is $277 with $95 for parts and $182 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1998 Buick RivieraV6-3.8L TurboService typeWater Pump ReplacementEstimate$849.60Shop/Dealer Price$928.43 - $1134.14
1995 Buick RivieraV6-3.8L TurboService typeWater Pump ReplacementEstimate$807.30Shop/Dealer Price$877.40 - $1072.04
1997 Buick RivieraV6-3.8LService typeWater Pump ReplacementEstimate$640.17Shop/Dealer Price$710.16 - $909.23
1999 Buick RivieraV6-3.8L TurboService typeWater Pump ReplacementEstimate$815.36Shop/Dealer Price$887.57 - $1088.32
1990 Buick RivieraV6-3.8LService typeWater Pump ReplacementEstimate$471.53Shop/Dealer Price$539.66 - $732.81
1996 Buick RivieraV6-3.8LService typeWater Pump ReplacementEstimate$640.17Shop/Dealer Price$710.52 - $909.87
1995 Buick RivieraV6-3.8LService typeWater Pump ReplacementEstimate$632.11Shop/Dealer Price$700.12 - $893.18
1992 Buick RivieraV6-3.8LService typeWater Pump ReplacementEstimate$442.33Shop/Dealer Price$507.88 - $699.09
Show example Buick Riviera Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Buick mechanics

Real customer reviews from Buick owners like you.

Excellent Rating

(31)

Rating Summary
28
2
0
1
0
28
2
0
1
0

Jay

30 years of experience
1009 reviews
Jay
30 years of experience
Riviera 1999 - Radiator - Riverside, CA
Jay is awesome! Very helpful and professional.

Excellent Rating

(31)

Rating Summary
28
2
0
1
0
28
2
0
1
0
Number of Buick Riviera services completed
341+
services done by our mechanics
TOTAL NUMBER OF EXPERT Buick MECHANICS
800+
experts on our platform

Recent articles & questions

What Is Dry Gas?
Dry Dry gas is a very helpful fuel additive that is used to remove water from gasoline and prevent water-contaminated gasoline from freezing. While the solution itself is actually called dry gas, there is one brand of this fluid named...
How Long Does a Vacuum Brake Booster Check Valve Last?
The The braking system on your car requires a lot of pressure. The vacuum booster is one of the main sources of this pressure. This booster will take the pressure that is put on the brake pedal and minimize it...
How Long Does a Courtesy Light Bulb Switch Last?
The The courtesy light bulb switch controls the courtesy light. When you open and close the doors of the vehicle, the courtesy light comes on to allow you to see better. This is both convenient and much safer for you...

car vibrates bad off and on at an idle and driving

Hello. You may have a few issues going on. It does sound like you have a bad axle. That will cause the noise when turning. The vibration is more than likely caused by bad engine mounts. Bad mounts will allow...

High idling on cold start

Hi there thanks for writing in about your 2006 Lincoln Zephyr. This sounds like a failing idle air control valve issue (https://www.yourmechanic.com/services/idle-control-valve-replacement). If this is confirmed, and the valve is replaced, there is also a 'relearning" process for the engine...

What happens if Load Sensing Proportionate Valve is deleted and brakes are connected directly?

If you delete the proportioning valve, too much brake line pressure will be directed to the rear brakes, and too little to the front, thus possibly causing the rear brakes to lock up with loss of control of the vehicle....

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com