High Pressure Safety Valve Replacement at your home or office.

Our certified mechanics come to you · Backed by our 12-month, 12,000-mile warranty · Get a fair and transparent estimate upfront


High Pressure Safety Valve Replacement Service

What is the High Pressure Safety Valve all about?

The high pressure safety valve, or oil relief valve, is located near the oil pump. When the oil is thick and cold, the oil pressure forces down the valves against the spring tension, allowing the oil to go to the engine bearings. Then, it returns it to the crankcase. The oil pressure valve makes sure that the oil pressure is consistent at all the bearings, regardless of the speed of the engine. At high engine speed, the excess oil escapes so that power isn’t lost by the driving the oil pump.

Keep in mind:

  • If the oil pressure safety valve is faulty, surplus oil can be delivered to the working parts of the engine and cause damage.
  • Excessive oil pressure can make it hard for the engine to drive the oil pump.

How it's done:

  • The vehicle is lifted and supported on jack stands. The oil pan is removed to access the oil pump safety valve on the pump.
  • The retainer clip is removed from the oil pump and the defective oil pump high pressure safety valve is pulled out.
  • The new valve is installed and secured. The oil pan is reinstalled with new gaskets. A new filter is installed and oil refilled.
  • All removed components are reinstalled. The vehicle is removed from jack stands
  • The vehicle is started and checked for oil leaks and proper oil pump operation.

Our recommendation:

If you suspect any damage at all to the high pressure safety valve, you should get it checked immediately. One of our expert mechanics can help you diagnose the problem and determine if a replacement is warranted.

What common symptoms indicate you may need to replace the High Pressure Safety Valve?

  • Sudden drop in oil pressure
  • Oil light comes on
  • General poor performance

How important is this service?

If the high pressure safety valves fail, that could result in a leaking or cracked oil cooler. If that happens, the oil pressure valves will have to be removed and examined, and that could be a very expensive procedure. If a valve ends up being stuck, excessive oil pressure can result, and there could be serious damage to the engine. Work with one of our expert mechanics if you discover any of the symptoms we have described above.

Fast and easy High Pressure Safety Valve Replacement service at your home or office.


Recent articles & questions

How to Replace a Lost or Stolen Car Title in Vermont
You've You've probably never given your car title much thought before. Really, unless you are transferring ownership of your vehicle, or selling it, the title doesn't come into play. That's exactly why it's so easy for it to go missing,...
P0709 OBD-II Trouble Code: Transmission Range Sensor Circuit Malfunction
P0709 P0709 code definition The P0709 code is known as Transmission Range Sensor Circuit Intermittent. What the P0709 code means The meaning of P0709 varies slightly among makes and models, but in general, this code indicates that the PCM (powertrain...
How to Replace an ABS Control Module
An ABS module can be a difficult part to replace depending on the manufacturer's design. You may need to reprogram and bleed the system if necessary.

How do you open the trunk with the remote?

You can open the trunk easily just be getting close if you have the Intelligent Key in your pocket, but you can also use the remote to open the trunk lid from a distance if you want. Here’s what you...

cranks but wont start - 2010 Hyundai Accent

Hello. If the code remained on after the sensor was replaced, then it may be possible that the fault is with the wiring or the ECM. I would verify that the wiring and connector to the sensor are in good...

if my 2011 chevy equinox brakes the water chain can the car still run or it'll stop?

Hey there, thank you for asking about your 2011 Chevrolet Equinox. The water pump and engine balance shaft are run on one chain and the engine crankshafts are run on a separate timing chain. I guess it could be possible...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com