Nissan 280ZX Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(12)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(12)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Nissan 280ZX Power Steering Pump Replacement is $385 with $214 for parts and $171 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1980 Nissan 280ZXL6-2.8LService typePower Steering Pump ReplacementEstimate$634.12Shop/Dealer Price$758.91 - $1092.77
1981 Nissan 280ZXL6-2.8LService typePower Steering Pump ReplacementEstimate$598.12Shop/Dealer Price$722.94 - $1056.82
1982 Nissan 280ZXL6-2.8LService typePower Steering Pump ReplacementEstimate$1222.08Shop/Dealer Price$1502.89 - $2304.74
1979 Nissan 280ZXL6-2.8LService typePower Steering Pump ReplacementEstimate$1222.08Shop/Dealer Price$1502.85 - $2304.67
1982 Nissan 280ZXL6-2.8L TurboService typePower Steering Pump ReplacementEstimate$823.92Shop/Dealer Price$1005.22 - $1508.47
1981 Nissan 280ZXL6-2.8L TurboService typePower Steering Pump ReplacementEstimate$823.92Shop/Dealer Price$1005.19 - $1508.42
1983 Nissan 280ZXL6-2.8LService typePower Steering Pump ReplacementEstimate$607.12Shop/Dealer Price$731.69 - $1065.39
1983 Nissan 280ZXL6-2.8L TurboService typePower Steering Pump ReplacementEstimate$607.12Shop/Dealer Price$732.36 - $1066.56
Show example Nissan 280ZX Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Nissan mechanics

Real customer reviews from Nissan owners like you.

Excellent Rating

(12)

Rating Summary
12
0
0
0
0
12
0
0
0
0

Raul

34 years of experience
285 reviews
Raul
34 years of experience
Nissan 280ZX L6-2.8L - Car is not starting - Fremont, California

Scott

21 years of experience
144 reviews
Scott
21 years of experience
Nissan 280ZX L6-2.8L - Headlight Bulb Replacement (Passenger Side Low Beam) - San Diego, California
Scott took his time and did the job right. Plus he was very friendly and earned my trust.

Michael

21 years of experience
244 reviews
Michael
21 years of experience
Nissan 280ZX L6-2.8L - Car is not starting - Fontana, California
Great guy

Jimmi

27 years of experience
231 reviews
Jimmi
27 years of experience
Nissan 280ZX L6-2.8L - Clutch Master Cylinder & Slave Cylinder Replacement - Winter Springs, Florida
Prompt and professional.

Excellent Rating

(12)

Rating Summary
12
0
0
0
0
12
0
0
0
0
Number of Nissan 280ZX services completed
132+
services done by our mechanics
TOTAL NUMBER OF EXPERT Nissan MECHANICS
1500+
experts on our platform

Recent articles & questions

When Does the Gas Light Turn On in My Car?
Going Going to the gas station is a chore and many of us wait until the gas light is on and the tank is nearly empty. But waiting until your fuel tank dries up is a bad habit, and the...
Hawaii Parking Laws: Understanding the Basics
It It can be difficult to find a parking space in Hawaii. Some people feel that they don’t have to obey the law and that they do not have to be courteous to others when they need to find a...
P0679 OBD-II Trouble Code: Cylinder 9 Glow Plug Circuit
P0679 means there is an issue with the cylinder 9 glow plug circuit. This may be due to fault in the glow plug's relays, module, wires, or connectors.

Water under passenger seat and mildew problem

If the A/C evaporator drain is clogged or partly clogged, then the water condensation from the normal A/C operation cannot drain out of the evaporator case and has to go somewhere. The place it usually goes is out of is...

Stalling & sputtering after rain

The engine spark plugs and spark plug wires on your 2001 Ford Escape are most likely arching to the ground and may need to be replaced. Run the engine with the hood up and listen to see if you hear...

When turning left or right clinking noise in the front.

Lift the hood and have someone turn the wheel back and forth while you feel the top of the strut under the hood and listen and feel for the upper strut bearings making noise. They may need to be replaced....

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com