Mercury Cougar Turn Signal Switch Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Turn Signal Switch Replacement Service

How much does a Turn Signal Switch Replacement cost?

On average, the cost for a Mercury Cougar Turn Signal Switch Replacement is $222 with $82 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1994 Mercury CougarV6-3.8L	Service typeTurn Signal Switch Replacement	Estimate$319.96	Shop/Dealer Price$364.80 - $491.22
2000 Mercury CougarV6-2.5L	Service typeTurn Signal Switch Replacement	Estimate$406.95	Shop/Dealer Price$470.56 - $656.84
1991 Mercury CougarV6-3.8L	Service typeTurn Signal Switch Replacement	Estimate$440.35	Shop/Dealer Price$515.80 - $737.96
1996 Mercury CougarV6-3.8L	Service typeTurn Signal Switch Replacement	Estimate$310.95	Shop/Dealer Price$354.05 - $479.16
1992 Mercury CougarV8-5.0L	Service typeTurn Signal Switch Replacement	Estimate$440.35	Shop/Dealer Price$517.27 - $740.54
2002 Mercury CougarL4-2.0L	Service typeTurn Signal Switch Replacement	Estimate$406.95	Shop/Dealer Price$470.74 - $657.16
1999 Mercury CougarL4-2.0L	Service typeTurn Signal Switch Replacement	Estimate$406.95	Shop/Dealer Price$470.60 - $656.92
1997 Mercury CougarV6-3.8L	Service typeTurn Signal Switch Replacement	Estimate$310.95	Shop/Dealer Price$354.05 - $479.16

Show example Mercury Cougar Turn Signal Switch Replacement prices

What is the Turn Signal Switch all about?

The turn signal switch, located inside the car on the steering column, allows you to turn the signal bulbs on. Properly functioning turn signal lights are legally mandatory.

Keep in mind:

The wiring for brake lights usually goes through the turn signal switch. This means that if the turn signal switch has gone bad, your brake lights may not be working.
Some vehicles use a “combination” switch. This switch operates the turn signals, running lights, and headlights.

How it's done:

Inspect the switch, fuses, and wirings.
Remove and replace the switch if faulty.
Operate the turn signals verify operation of the exterior lights.

Our recommendation:

If your turn signal lights do not operate, your mechanic will visually inspect the fuse(s) and operate the switch a bit to see if he can determine where the problem is. Your mechanic should inspect all lights during every major service event.

What common symptoms indicate you may need to replace the Turn Signal Switch?

Left or right indicator light is not working.
Brake lights are not working.
Running lights or headlamps not working.
Unable to change from high to low beam and back.

How important is this service?

When you deploy the turn signal lever on your steering column, the turn signal switch is responsible for turning on your turn signals. Turn signals are a very important safety feature that alerts drivers all around you that your vehicle will soon be making a turn. When your turn signal switch dies, you have no way of turning on your turn signals. This not only makes your car less safe, but it is also illegal, and you can be given a very pricy fix-it ticket.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Mercury mechanics

Real customer reviews from Mercury owners like you.

Excellent Rating

(81)

Rating Summary

72

6

2

0

1

72

6

2

0

1

SEE REVIEWS NEAR ME

Robert

21 years of experience

1307 reviews

Robert

21 years of experience

by Thomas

Mercury Cougar V8-5.8L - Fuel Pump - Arvada, Colorado

He was prompt and didn't waste time. Seemed very knowledgeable.

Peter

37 years of experience

346 reviews

Peter

37 years of experience

by James

Mercury Cougar V6-3.8L - AC Compressor - Phoenix, Arizona

The AC compressor that he replaced stopped working three days later. Peter came back out to diagnose the problem and sure enough the compressor stopped working. Two days later he installed a new one, but it too wasn't working. Peter determined that the condensor was clogged which is why first compressor failed. He immediately ordered a new condensor which would not be available until after lunch. A few hours later Peter returned and installed the new part outside in my parking lot when it was 106 degrees in the sun. Since the compressor was in warranty he replaced it and didn't charge me for the new part nor did he not charge me the labor to install it. He also gave me a fair price on the new condensor. Peter is honest and fair. He is not your ordinary mechanic out to see how much he can make off you. The rates are very reasonable.

David

15 years of experience

103 reviews

David

15 years of experience

by Tony

Mercury Cougar V6-2.5L - Inspection / Diagnostics - Austin, Texas

Professional, punctual and a great guy to work with.

Ronald

42 years of experience

519 reviews

Ronald

42 years of experience

by John

Mercury Cougar V8-4.6L - Spark Plugs - Spring, Texas

Ron perform as a professional He did a Great job I would recommend him to anyone Will request him on my next service on my auto. John S

Excellent Rating

(81)

Rating Summary

72

6

2

0

1

72

6

2

0

1

SEE REVIEWS NEAR ME

Recent articles & questions

How to Lubricate Your Car's Hood Hinges

Hood hinges secure the hood in place and protect your engine bay. Over time, hinges begin to wear out which causes noise and hood misalignment.

Symptoms of a Bad or Failing Traction Control Switch

Common signs include the Check Engine Light coming on, car braking inconsistently, and the traction control switch not depressing.

How Long Does a Clutch Cable Last?

The The clutch cable is an essential part of your vehicle’s clutch system. The clutch is a device that engages and disengages the power transmission, and allows you to shift gears while you are driving. Manual transmission vehicles have a...

Key fob won't unlock or lock doors

I believe you should have a technician use a capable scan tool to test the immobilizer and security system of the vehicle. There are likely codes present that will lead you directly to the issue. Also have them test the...

My car jerks from 0-25; and backfires.

Some of the things that a technician might suspect and decide to test on your Kia would be the cam timing (timing belt might have jumped), crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) function, engine compression, and fuel pressure. Using a scan tool...

Spilled drink on my gear shifter on my Toyota RAV4 2015 model, need some help in taking it apart and removing it to clean it

Hi there. We really don't have a service for this particular application quite yet - but, we might be able to help you. There are two options to consider. First, you can purchase a service and repair manual that should...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com