Mercedes-Benz SL320 Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(5)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(5)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Mercedes-Benz SL320 Water Pump Replacement is $881 with $254 for parts and $627 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1995 Mercedes-Benz SL320L6-3.2LService typeWater Pump ReplacementEstimate$1267.33Shop/Dealer Price$1509.95 - $1977.89
1997 Mercedes-Benz SL320L6-3.2LService typeWater Pump ReplacementEstimate$1135.33Shop/Dealer Price$1378.16 - $1846.25
1996 Mercedes-Benz SL320L6-3.2LService typeWater Pump ReplacementEstimate$1135.33Shop/Dealer Price$1378.14 - $1846.21
1994 Mercedes-Benz SL320L6-3.2LService typeWater Pump ReplacementEstimate$1135.33Shop/Dealer Price$1377.88 - $1845.76
Show example Mercedes-Benz SL320 Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0

Chris

15 years of experience
312 reviews
Chris
15 years of experience
Mercedes-Benz SL320 L6-3.2L - Back To School Promo - San Diego, California
Chris does excellent work, he gets right down to business and finishes ASAP so you can get on with your day!

Robert

12 years of experience
125 reviews
Robert
12 years of experience
Mercedes-Benz SL320 L6-3.2L - Car is not starting - Silver Spring, Maryland
Robert was early to our appointment, diligent, thorough, personable, efficient and friendly.

Attila

19 years of experience
884 reviews
Attila
19 years of experience
Mercedes-Benz SL320 L6-3.2L - Battery - Avenel, New Jersey
Outstanding

Jarius

21 years of experience
49 reviews
Jarius
21 years of experience
Mercedes-Benz SL320 L6-3.2L - Car Battery Replacement - Silver Spring, Maryland
Jarius Foster was early for the appointment, very courteous, efficient and skilled. While I was expecting an hour long visit, Mr. Foster was finish in just 30 minutes. I would recommend him to all.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0
Number of Mercedes-Benz SL320 services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1000+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Dodge Challenger
The The 2012 Dodge Challenger has high performance, great features, and good pricing. It is comfortable for every day driving while still providing enough space for four people and their cargo. Key Features Under the hood of the vehicle is...
How to React When Your Oil Light Is On
You’re driving along and you notice your oil light (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-the-oil-light-on) come on. You’re on your way to work and...
P000B OBD-II Trouble Code: “B” Camshaft Position Slow Response
P000B means that the ECM has detected a fault with the position and timing of the camshaft due to a loose fuel cap, or low oil pressure.

Driver's side door won't open

If the driver side door will not open then most of the time this is caused by a broken door latch that should be repalaced (https://www.yourmechanic.com/services/door-latch-replacement). If neither handle works then the latch is broken inside of the door or...

Finding a rear axle leak on a 2000 Dodge

Normally it is either the gasket that is leaking at the back or the seal is leaking on the front pinion shaft where the drive shaft goes in and spins around. If you really want to find out what it...

There's no milky residue on my oil cap or my dipstick but there's oil in my radiator I know I have a bad spark plug wire.

Hi there. A bad spark plug wire would not allow engine oil into the cooling system. The possibility of a bad head gasket, could allow engine oil into the cooling system. Assuming the engine has not been overheated, electrolysis could...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com